52'' GE Projection TV will not turn on

Tv needs to be realined by adjusting the Screen Drive Controls to Tubes.
Located behind the Front bottom Panel on front of Tv.
Focus/Screen Control Block 3 on top for focus and 3 under them for screendives to each Tube R/G/B.

Without more detail it's impossible to say for sure. It sounds like the bulb may have gone bad and that needs to be replaced.

Most likely the Horizontal output transistor has shorted. When it shorts it causes the power supply to chirp. This is a common problem with this series of TV. Have a shop check it out. It should not be real expensive.

replace the remote, dah.......

Hi, thats the code for AKB fault, this requires a tv tech to fix,, not a big bucks repair, video-tek

first try to reset the tv configurations and parameters.

if the problem still : test the speakers with a metrix then and the sound board/circuit and see what can u replace

plz do rate this post

it is your provider not the tv, i had the same problem. they just seem to lazy to fhelp you.

5 blinks means problem in the AKB (video) and 4 blinks means problem with the verticle deflection. Try this to get the screen to display any recent faults then get back to me and let me know what it said. Press the following buttons on the remote.
Display, Channel, 5, Vol Minus, ( Not plus ) then Power. This brings up
a screen with a list of the problems and number of times they have occurred.
Each of the problem names is abbreviated as, "OCP", "OVP", "V STOP", ETC.
We have repeated them in parentheses in the text for the "Blinks" described
above so you can correlate between the diagnostic screen and the blink
codes.

Use your input button on your television's remote control.... you should have plugged the wires into the COMP 1 area on the back of your TV.  You will also need to make sure your red and white audio cables are plugged in as well (Five total plugged wires) Press the input button until you see COMP1 at the bottom of the screen... there you will find your picture and sound.

believe it or noT: try replacing all of the switches on the control panel (((power button switch,menu button switch, etc...)))