20 Most Recent Durabrand DWT1905 TV - Page 2 Questions & Answers

Check and replace its main system control memory IC.

1061 1203 1177

0628,0982,0184,0278. Check these codes. If you wish to get more details, check this site. Pull up previous posts there. Setup code list and setup proceedings to many popular brand remote controls are given. Three digit, four digit, five digits and two-digit code list are there. Check the site with patience. Surely you'll get a solution to your problem. Search the site by 'Timeslide' option. It will make search easy. Or, type in the brand name to your device into its search box, and press "Enter"

Your set is in service mode now. You have to exit it. If you wish to get more details about how to enter and exit service mode, visit this site. It has details to many brand and models.

There is no sound card separately. The audio output circuit is a part of the main board itself. Check its speaker first.

These are the setup codes for Duraband TV.0189 0135 0157 0153 0254 0458 0217

0189 0135 0157 0153 0254 0458 0217

All you need is to press the input select button on the remote to change between the tv and the video inputs.

Try 0463, 0180, 0178, 0171 or 1034. These were listed as TV codes at www.hifi-remote.com. If they do not work, try 1127, 2164, 0038, 0039 or 1561.

so you can be helped on local electronics store, ask a remote replacement for your tv, or they can help you program to your tv.

Hello
A thin horizontal line across the screen denote that the vertical swep or output has damaged, or there are some loose solder points to vertical output section. Loose solder problems are very common to the vertical output sections of most of the picture tube based TVs. Just open your Tv, and pull out the main baord out of it, which has the vertical output section circuit. You must have some knoldge in electronics to proceed. Locate the vertical output section. usually, this section will be composed of an IC, which will be screwed on to a metal heatslink, to radiate heat out of it when it works. Check whether there is any loose solder terminals at this section, especially look for it at the solder terminals of IC and other components around it.
It is very difficult to detect the loose solder points, as some of them may be so microscopic to detect. Just do, what we do at service table, with this type of fault comes to us. Just resolder most of the suspected solder terminals by applying a little more solder without making any sokder bridge short between adjecent solder terminals.
If this does not help you, check the input voltage to the vertical IC. If found OK, replace the vertical output IC. If there is no voltage to this IC, check the track that brings voltage to that IC. Usually, this voltage will come from one amoung the terminals of LOT [Line Output Transformer]. Check the track, rectifier diode, limiting resistor etc. This is really a skilled work, and you should have all tools for an electronic work, and a skill to detect the faulty component. OK

This shutting on and off~On Durabrand TV`S. If your Tv Turns Off after about 1-11/2 minutes after turning it on then you need to replace your batteries in your remote control with BRAND NEW BATTERIES or it will keep doing it. It is a real pain in the behind especially if you dont have brand new batteries handy!

Try to check this link http://www.replacementremotes.com/Durabrand/Replacement-Remotes-New-OEM-TV-DVD-Remote-Controls-page-1.html good day and best regards hope this help.