Top 20 Infinity BASSLINK Car Subwoofer Questions & Answers

I am going to refer you to the live help at crutcfield.com audio They can give you ideas on compatible equipment and designs that will achieve your desires without the OBVIOUS overlad/mismatch. Your search for comparison returned these articles Free factory (usa market) wiring diagrams BBB Industries Premium Alternators Starters Power Steering Products

Is there an existing sub in the car .

I would get a test light and see if the remote line is still working. Otherwise, yes you probably fried it. Doesn't take much in car audio to fry an amp.

Check the fuse in your car's fuse panel. If it is burnt then change. If it is still good, check the fuse on the head unit and amp.

Free PDF Service Manual can be downloaded from the following link.

http://forum.electromaniacs.com/topic/18659-infinity-infinity-basslink-car-subwooferpdfzip/

You need to join the by creating a username and password, once you've received your verification email you can downlaod the file. There is no cost to join this site or download the file.

Run the ground back to the battery. The body is not a good enough conductor.

what are you talking about unit01, you talk too much but isn't revealing the main prob. it's the Electronic board that is deffective that's why it's turned on, but no sound, because the board of the sub is not operating anymore, maybe a busted capacitor or IC. that's why. ok? don't listen to unit01, it's a non sense talks lol

Hello, check the +15v and -15v on the Switching Power Supply Control board. If one or both are missing, it is probably Q117 for +15v and Q118 for -15v. If one is missing the limit comparator will rail to one side and cause the auto variable volume control to trip the servo protection.

Hi,

You can download the complete instruction manual in PDF format by clicking this link.

• You'll require Adobe PDF Reader installed on your computer to view the manual. If it is not already installed on your computer, download it free from: http://get.adobe.com/reader/

Hope this solves your problem. Thanks for using FixYa.

Hi,

One or more of the DC to DC outputs might be bad. Check the
/- 54v on the main PCB and the /-15v on the switching controller PCB.
Losing one side of the 15v will cause the limit comparator to rail and force the servo protection, even with no input signal.

i think you dindt but the remote right were it suppose to

if it has a short some where in the lines it will do that

Simple as it sounds, try Home Depot/Lowe's! They will have them! Been there, done that!

go to the website that built the part. they usually have manuls you can download and get exact part number.. then go to ebay or google t for fix andddd parts cosr

If the sub already has an enclosure, (box) put some legs on it and enjoy! If no enclosure, you will need to find out what size and type of box you want, go to a car audio dealer. I have replaced my home speakers with car speakers, MAKE SURE YOU KEEP THE OHM RATIMG THE SAME!!!!!!!!!!!!!!!!

Sad to say but this usually happens when one of the capacitors go bad or something else internally. Most of the time it's cheaper to get them fixed, but I have seen them get up there too! Hope this helps some.

Hi,

Does the servo led stay on? If so, you might have a fractured solder joint. Inspect the switch control PCB for fractured solder joints and check the Positive and Negative 15v outputs on the same board.

check that fusse under the hood if its blown pull it out and replace it wont hurt anything if u pull it out an put it back in if the cars off.but if ur getting power lights on the amps then more then likely ur fuse isnt blown.id start by checking the audio cables are produceing sound.if u need more help let me know [email protected]

remote wire hooked up also?