20 Most Recent
Noritz 6.9 Gallon Residential Tankless Water Heater - N-069M - Page 6 Questions & Answers
Water is not hot enough and the temp is on 120
check your gas pipe size. make sure you have enough gas running to the unit. also turn all your faucets on hot and turn off the cold water to the heater and see if you get any water out of the hots anywhere, that could mean that you have a cross connection.
Fan cycles on every few minutes.
You're most likely getting a pressure wave (spike) that is generating momentary flow across the flow sensor. The heater is registering this "instant" flow and beginning its firing sequence. Once the flow dissipates, the unit then goes into a purge cycle. I'd recommend having your water pressure tested to make sure it isn't abnormally high (above 60 psi) or abnormally low (below 30 psi). Assuming the pressure is normal, you can use a pressure reducing valve or pressure regulator to absorb the spikes and stop the unit from cycling.
What is error code c8 mitsubish heater
The P8 fault can mean many things when it pops up on your Mitsubishi Electric wall controller. The P8 fault is activated when the indoor coil sensor does not change the temperature for a set amount of time after the compressor is (or should be) switched on.
Rival titan floor heater coils don't turn red
Beware when working with electrical equipment. It may cause electric shock.
Check the power supply wires, connections with heating coils. If they are ok then possibly heating coils require replacement.
Not finding what you are looking for?