...trolling motor. Where the lower shaft that holds the prop goes into the larger shaft that has the motor the plastic ring has come apart and the bearings fell out. How can I replace this and where can ...
trolling motor and i got the shaft loose from the top and bottom but don't see how to get the wires loose. I tried to take apart the control panel and all the screws are rusted and just crumble when i
...trolling motor I have an Endura 30 also and haven't been able to find an owner's manual or a service manual. I did find a schematic which is almost as good as a service manual. It gives an exploded ...
Question about Minn Kota Boating
...apart anymore and are not paying attention it will fly out and it took me hours to get it back together I have a used Minn Kota Model 35 24lb thrust transom trolling motor with a s/s prop how do I ...
you could have a broken gear inside the top of the motor. take the cover apart and you will see 3 plastic gears. one on the motor shaft, one on the indicator and one in between. check all gears are ok
trolling motor will not operate. charge indicators show no charge.I know this is not the problem. Have installed new batteries. I checked voltage at plug and have 26 v. When I plug the motor in the ...
...trolling motor apart. I had an issue getting the brushes back on but figured that out. A couple of the wires came undone and i plugged them back before closing the motor up. Now the trolling motor ...
Question about Minn Kota Boating
trolling motor that was hooked up pos. to neg./neg. to pos. now it wont' work at all. Can't find a fuse or breaker.....Any solutions out there???? Unfortunately, those units have a circut board at the
...to order parts & repair mine. It is even done in such a way as to illustrate how it comes apart and goes together. Here's the link:
...motor has either bearings going bad and/or water has gotten in the housing washed the lubricants out. Motors do wear out eventually. I'm not sure if the brushes are replacible. Have you checked for ...
131 questions posted
Usually answered in minutes!