check engine light is still on. You asked that I get back to you once I drove the car after repairs, so it could go through it's cycles. Well it's 200 miles later and I am following up on the March 16
Question about Toyota Corolla
...check engine light on clearing usually doesnt clear codes unknown code so with minor leak usually gas cap ---but--it also can be anything in the evap system cracked hose --canister--valve etc check ...
tiguan 2010 showing misfire why? check engine light on showing misfire use this tool to check your car,to find what's wrong with your car and use it to clear the fault codes.
...check engine codep0050 I HAD CODE SCANNED AND I AM TOLD THE P0050 CODE RELATES TO THE O2 SENSOR HEATER RELAY OR FUSE.UNDER THE HOOD THERE IS A RELAY/FUSE BOX BUT NOTHING IS MARKED IN RELATION TO THE ...
...clear the checkengine light using a scanner on ... KIA Check Engine Light (CEL) Codes - Kia Forte Forum : Sedan ... www.forteforums.com/.../11832-kia-check-engine-light-cel-codes.html May 20, 2012 - ...
Question about Cars & Trucks
...check engine light is on. How do I clear it Any code's stored ? Or didn't you check ? Check engine light on code or code's stored . After replacing or disconnecting a battery in a ford vehicle will ...
Question about Toyota Corolla
free to see if you have any issues...And clear the codes with scanner...This way you can check for unseen problems......But you are probably safe if car has been well maintained.............Brooks....
Question about Hyundai Cars & Trucks
...Check engine light with code P0501. Speed sensor. Known front right location. replaced sensor, cleared code, and check engine light goes on and same code of P0501. What gives? " Known right front ...
check air filter make sure it's clean, replace if needed then use above method to clear light Hopefully that works if not you'll need an OBD2 scanner to get the code ...it's likely something in EGR, a
...clear the code it stays off. But on cold start it comes back on. Also fitted new battery but still comes on check you have power at the glow plugs . fit test light clamp to ground and probe the glow ...
1,034 questions posted
Usually answered in minutes!
1,231 Questions
1,240 Questions
1,236 Questions
819 Questions
767 Questions
