Hyundai Motor 2000 Tiburon "battery cable" Questions

...from a stop and shifter in D. no other shift problems up or down. Try this first. Disconnect the battery cables from the battery. Touch/connect the two cables together for 60 seconds. Reconnect

...it up so you can remove the clamp that holds the battery down. Remove negative battery cable first, then positive cable. When putting the cables back on, positive gets put on first, then

BATTERY TERMINALS, REMOVE NEG. CABLE FIRST, THEN THE POS. CABLE CLEAN BOTH CABLES & BOTH BATTERY TERMINALS BRIGHT & SHINNY. PUT POS. ON BATTERY & TIGHTEN. LAST THING PUT NEG. CABLE ON &

battery cable etc. A Simple Check for the Alternator is once the car is running - (If you Jump-started then Remove the Jumper-Cables) - If the engine continues to run, then disconnect the Ground Cable

...it by either an OBD II scanner (auto zone, car quest, pep boys, etc) or simply by disconnecting the battery cables from the battery posts and touching the cables together for 30 seconds... then ...

battery cable both at the battery and at the termination points, such as ground and starter motor. Check that the battery wires are tight and clean at the battery posts and at the other end. Again the

...battery cable Air intake assembly Clutch slave cylinder Speedometer cable Shift cables Starter motor Axle halfshafts Flywheel cover Transaxle mount Transaxle flange bolts Transaxle To install: NOTE ...

.... Buy a battery cable remover. It lookc like a clamp. The hooks go under the cable end and the post goes to the center of the terminal. When you turn it, the terminal will pop right off. About

I have a 2003 Hyundai tiburon. I need to replace the battery. I disconnected both the positive and negative cables. I cannot remove the battery no matter how hard I try. Is the battery bolted down? ...

...CABLE JUMPER CABLES LIGHT DUTY CABLES WON'T DO THE JOB. IF IT JUMP STARTS, CHECK THE ALTERNATOR. WITH MOTOR RUNNING, VOLTAGE AT THE BATTERY SHOULD READ BETWEEN 13.90 & 14.80. REMOVE JUMPER CABLES ...