...its not getting fuel. I have replaced the max airflow sensor/fuel pump/crankshaft sensor and the ecm. check your ecm ...
...1996 dtc codes, i look to the ecm and does not have any switch to change to self-diagnostic mode. thank you There is a connector under the steering column, you need to buy an OBD 2 system scanner to ...
ecm is going or i could even be the computer nissan is a good car but it will be expensive to fix I had this problem with my 1996 nissan I removed the odometer and speedometer, I found that the screws
Will start but no power My 2006 Nissan Sentra Special Edition will start and idle but will not rev. IT CAN BE YOUR ECM CONNECTION
1996 nissan sentra ecm location Under hood, driver side, mounted on side of strut tower
Does 02 Sentra gxe 1.8 has a self diagnostic on its ecm/ecu Not like the models built before 1993 did. You use a code reader or scanner like any other car built after 1996.
Question about Nissan Sentra
...no matter what brand new distributor, crank sensor, plenty of fuel pressure. Bad driver in ...
...SENSOR TO check the coil,,or the coil lead to the distributor ,,,could be faulty,,, Check your ecm, looking for scorching and corrosion. Replace with rebuilt, costs about $180 with your
...1996) si too low, replace spark plug, cables, etc, sensors its ok, but rpm still low. Tank you very much The idle speed is computer controled, it is not adjustable, you most likely have sludge in the ...
...1996-newer), although specific repair steps may vary depending on the model. On electronically controlled transmissions, the Output Shaft Speed Sensor (OSS) is located on the end of the transmission ...
1,247 questions posted
Usually answered in minutes!
708 Questions
716 Questions
570 Questions
508 Questions
442 Questions