Question about Chevrolet Silverado 2500HD
...relay or wire leads at the speed resistor by the blower motor under the glove box by the passenger leg compartment. Keep me posted, be glad to help you get your Silverado running 100% again
the blower hard underneath the glove compartment , this is my 95 accord ex, do u think i need to replace the whole thing, I think you need to change the entire blower motor under the glove compartment
blower motor that is located under the glove compartment. The make of the car is an Infiniti I35. I difficult is it to remove the glove compartment? six screws hold the glove box two at bottom four at
Question about Chevrolet Silverado 2500HD
...under the instrument panel. steps Blower Motor Removal Remove the footwell lower trim panel passeger side. Open the glove compartment. Remove the footwell vent air duct. Pull off the hose. Close the ...
Question about Chevrolet Silverado 2500HD
...blower motor itself, which can be found under the dashboard, on the passenger side of the car. To access it, you have to remove the glove compartment and the isolation panel that covers the bottom of ...
Question about Cars & Trucks
...blower motor located conflicting answers so far: location behind glove compartment or under the hood passenger side. If in glove compartment do I need to pull cover off of blower motor? or pull out ...
Question about Chevrolet Silverado 2500HD
...BLOWER MOTOR. It's quite a job to do,but if your up to it here's the step's. 1 REMOVE THESE PART'S a. cowl side trim right hand side b. front door scuff plate right hand side c. no.2 instrument panel ...
blower motor speed control resistor. I've looked under dash, pulled out glove compartment, looked on firewall, I give up. If its not near the blower motor, it may be on the hvac box on the firewall in
...under the dashboard. Install the new blower motor just as you removed the old one. It will not fit through the glove compartment hole. You have to raise it up from under the dashboard. Return and ...
under the glove box by the blower motor. If you are going to replace the blower resistor pack, replace the wire harness to since they are also known to go bad from the heat created from the electrical
206 questions posted
Usually answered in minutes!
241 Questions
48 Questions
21 Questions
5 Questions
4 Questions