replace the balancer assembly. Balancer on the crankshaft.Apply thread sealer (GM 1052080) or equivalent to the threads of the balancer bolt.Torque the crankshaft bolt to 140 Nm + 56°(104 lb.ft +
...replace crankshaft position sensor The sensor is located at the bottom of the engine behind the harmonic balancer. To the right side of the motor. You have to remove the pulley to replace the
crankshaft position sensor. I just bought the car and need to know if I have to replace this at this point the car is running fine IF THE CRANK SENSOR GOES BAD ON THAT ENGINE THE CAR WILL STOP RUNNING
...replace the crank sensor, its next to the crankshaft pulley. To test the old one run until it gets hot and cuts off, spray some water on the sensor to cool , if it restarts that is the problem. You ...
...crankshaft position sensor is the most common failure point, to replace it you must remove the front crank pulley and the harmonic balancer behind that pulley, the crank sensor is behind that and is ...
sensor but thats not it? It seems like it needs the idle control position sensor or the camshaft or crankshaft position sensors. Take to autoparts store for free scan for trouble code
...now it just starts and immediately dies. We are stumped, could it be the fuel pump? Did you change crankshaft sensor and cam
...replace a crank sensor on a 95 buick regal 3 8, most of all just have an idea how to remove the crankshaft. That's the problem. Crank sensor is not in the crank case itself... it is behind the ...
...crankshaft position sensor. The catalytic converter maybe clogged. This would result in a car starting then cutting off. you can unbolt the catalytic converter see if that solve the problem. Then if ...
How do i replace crankshaft sensor ? The crankshaft sensor is located on the engine block near the oil pan, disconnect connector and unscrew the sensorfrom the block and screw in the new sensor
446 questions posted
Usually answered in minutes!
757 Questions
631 Questions
489 Questions
420 Questions
426 Questions