1996 Mitsubishi Mirage "bracket holds pulleys front engine" Questions

...bracket. Rotate the pump toward the engine and remove the belt. To install: Install the belt on the pulleys. Rotate the pump until the proper tension is reached. Tighten the adjusting bolts on the ...

front of mounting bracket are loose they thread into the pump and hold it tight against the bracket. There is also an adjustment depending on what engine you have there will be a bolt or a stud with a

...bracket to the engine front cover. Remove the pulley and bracket. 4: The crankshaft pulley screws into the harmonic balancer with a left hand thread (reverse threaded so rightly loosey lefty tighty). ...

...bracket holds the crankshaft sensor firmly on the engine, and it is partially hidden by the crankshaft pulley. It has a four-wire harness connector, which provide the signal to the ignition control ...

...bracket power steering pump lower rad hose heater hose then 4 bolts hold the water pump onto the front of engine not hard at all dont be afraid to do it clean the block with a new razor blade glue ...

...bracket. Remove the crankshaft pulleys and torsional damper. Remove the timing belt covers. Rotate the crankshaft until the sprocket timing marks are aligned. The crankshaft sprocket timing mark ...

...pulleys. Place the right-hand engine mounting bracket in position but do not install the bolts. Install the upper (No. 2) timing cover with a new gasket(s). Remove the engine crankshaft pulley bolt ...

...bracket. Install right side engine mount. Install crankshaft damper and pulleys (Fig. 68). Tighten damper center bolt to 135 Nm (100 ft. lbs.) . Install accessory drive belts. Install accessory drive ...

...front wheel. RH inner wing panel. Air filter assembly. Support engine. Remove: RH engine mounting and bracket. Timing belt upper cover, AC receiver/drier (if fitted). DO NOT disconnect hoses. Timing ...

...bracket.7Place the alternator belt around the alternator pulley and check the position of the belt around both the crankshaft and alternator pulleys to verify that it is seated properly.8Place a crow ...