2000 Buick Century "windshield wiper splines" Questions

...windshield wiper quit working if the passanger wiper stopped working AND the drivers side is still working...one of two problems. the easiest is to pop off the black cap at the base of the wiper arm, ...

...windshield wiper motor on a 1990 Jeep Wrangler? inside the windshield frame, the wiper arm linkage splines onto a rotating arm on the wiper motor. The nut came off the wiper motor on my '93 YJ where ...

...windshield wiper motor. Where is it Trying to find windshield wiper motor for a 1999 Mercury Sable LS. Where is it located and how do I get to it? I can hear the motor working, but wipers won't move. ...

...windshield wiper stops on wrong side, what can I do?'. Kia Sorento 2007:My windshield wiper stops on wrong side, what can I do?'. If the wipers are consistent in where they stop the ...

windshield wiper How do you time the windshield wipers on a 1996 GMC truck. I replaced the wiper motor and the wipers will not lay at the bottom of the windshield I just take the arm off and ...

...and making sure wiper switch is OFF. Turn off ignition. Pry off the black round plastic cover off the arm where it attaches at the splines. ( Drive splines on lower windshield cowl.) Tighten

wiper arm comes down too far and not far enough on windshield just loose the nut holding the arm in motor shaft spline,manage to pull it slowly up off splines,put the wiper blade paraller  to the

...windshield wiper works the wiper arm is connected to the motor, but the drivers side wiper doesnt move at the same time, eventually causing the wipers to hit each other. They dont wipe in Sync. The ...

windshield left wiper stays loose after tighting loose bushing or what you may have a bad set of splines either on the wiper transmission arm that the wiper arm attaches to or the splines in the wiper

the windshield wiper parks full up. everything the windshield wiper parks full up. everything else works fine . remover wipers an set them down on a spline