1999 Dodge Intrepid "replace cam sensor 99" Questions

...replace the plug wires? You need to scan it for codes. It's most likely a missfire, but it could be a bad speed sensor (also called, VSS vehicle speed sensor, cam position sensor,or crank position ...

replace the PCM as required Ive found these cars have timing chain problems and also cam gear problems, the gear move off postion cause the code, you would need to first make sure the timing marks all

...sensor or cam position sensor because these are the signals affected by this problem in that harness. Apparently they rub at that point near the steering shaft and a few other places also causing ...

...cam sensor fails, the engine will not start. both of these sensor circuits can be checked with a voltmeter or lab scope. If the sensors are receiving the correct amount of voltage and have good ...

...Sensor was leaking thru it, I replaced it ($13) and my problem went away. You should take a look at yours, it is located on the passenger side, engine block almost under the exhaust pipe. Also add a ...

...replace the cam sensor. Iffy it still does not start replace the crank sensor and the cam sensor. The crank sensor is located on the passenger side of the engine block behind the starter. The starter ...

...cam sensor and it is working properly it is upside down from the 95 but the ASD relay is operating so I assume it is intalled correctly for the 95 PCM. The crank sensor is also working properly the ...

idle around 500 rpm now it idles somewhere around 1,300 rpm to 1,400 rpm. Engine has 153,000 miles and has had cam sensor and crank sensor replaced at approx. 120,000 A vacume line fell off or leaking

...cam sensor located on a 99 nissan quest? I have a 99 Mecury villager with the same engine setup as the Quest I was driving and the van died and will not restart I got the codes P0325 and P0340 any ...

...cam position sensor and still no spark in a 99 dodge avenger what could be the problem Often, modules and sensors are not the problem, rather the wiring that connects them. Check wiring attached to ...