1999 Dodge Intrepid "2 ignition problems" Questions

...2 ignition coil. To locate the #2 ignition coil look at diagram below. 1 - 3 - 5 < - - - Front of vehicle 2 - 4 - 6 If connection is good next you need to check for a short in the wires between the ...

ignition switch. The first thing you need to do is remove the steering column covers. Put the tilt steering all the way up. Look under the steering column cover. There are 2 phillips head screws and 3

...2 coil is integrated into the coil pack) You should also check the spark plug and ignition wire, an excessive spark plug gap or a bad ignition wire will cause the coil to work harder and shorten the ...

...IGNITION COIL. usually when coil dies the computer shuts off fuel pump to stop you catalytic converter and engine filling up with gas! do you have a eng light on if so scan with:OBD 2 scan to retreve ...

...2. Recheck to see if vehicle will start. 3. You will want to have the battery and alternator tested to be sure you replace the faulty part... if vehicle cranks, there might be a problem in the ...

...2 inches. I wrapped them in electrial tape. Do you think that could have been the problem ? He has had a new ignition switch and a couple other sensors replaced and still has the problem. Spray ...

...2 sensor ,chrysler told me after 600 $ of time ,that my problem was the flaxplate on top of the transmition after verification everyting is good What's your mileage? When the flatpack ignition module ...

...2- Are the connections of the injectors, ignition sensors, etc. will fit on the 3.3 engine? 3- Is the 3.5 engine computer will run the 3.3 engine? 4- Your advice is highly appreciated. It can be but ...

...2. take off your spark plugs and put new ones. if not work... do this. reset your ecu (like I say before) take your ignition coil #6 and change the place with another one on the same head side. ...

...2 weeks. Then the car just stopped running. It would turn over but it would not fire. I replaced the crank and camshaft sensors. That did nothing. I replaced the ignition switch and the car started ...