...touchpad.... On the smh9207st remove plastic cover from the back of the door . Remove 4 screws and 1 screw at the top of the door . Unplug two connectors Gently. ... Peel off front touchpad . Install ...
Question about Whirlpool Microwave Ovens
...is getting to the connector which carries the signals from the touchpad to the microwave controls. We had to remove and dissassemble the door to get to that connector. The touchpad cost about
...touchpad buttons are loose. how does one remove the cover of the panel to access the touchpad area. i was able to reach in from behind and maneuver them but they are loose and fall back down if i ...
ge profile microwave oven touchpad not working touchpad not working The touch pad is more than like the problem. This is common. Try removing the ribbon connector and reinserting it back in the ...
...the front panel. If you do venture in you should first unplug the unit and when the outer cover is removed, discharge the large capacitor with well insulated pliers -= otherwise keep well away from ...
Question about Kenmore Microwave Ovens
...touchpad Check to see if the touch panel is connected to the main board via a ribbon cable. If it is, carefully remove and clean the end that attaches to the circuit board. Electronic contact cleaner ...
Question about Microwave Ovens
...remove the touchpad, let it air dry for a few days, and then attach it back on the microwave. main control board to ensure that a shortage has not occurred. If the part is defective then it will need ...
Question about KitchenAid Microwave Ovens
remove the touchpad, let it air dry for a few days, and then attach it back on the microwave. Read more: http://www.appliancepartspros.com/repair-help/microwave-repair-help.html#4#ixzz2hVdoScpK http:/
...This solved the problem. J. Adams,Alabama The installation was not simple. The door has to be removed and disassembled to enable you to get to the connector that connects the touchpad with a ...
...remove the membrane touchpad? Every microwave oven I've seen has the touchpad permanently glued to the controller housing/front trim piece. To get this off, remove the top/side cover piece, then look ...
98 questions posted
Usually answered in minutes!
258 Questions
74 Questions
77 Questions
63 Questions
47 Questions