...burner tube, and not a big gap between tube and flame. Signs of soot (black) up the cover, or side of trailer means it's running too rich, and you've gone too far thus needs more air. Keeping the ...
...side and the other is working fine. Replaced the FV Sensor, but cannot get heater to restart. Lights stay on. Tried turning breaker off and then back on. iIf main burner is comming on then going off ...
Question about Water Water Heaters
...burner.The pilot light gas is controlled by the thermocouple which the side of the pilot flame has to envelop. If the flame is too small or too far away from the flame, it shuts the gas off to the ...
Question about Atwood Water Heaters
...burner tube. Too many people think more air, less fuel, but actually, when flame roaring and jumping off end of tube, the heat passes through faster and it takes longer to heat the water inside the ...
...burner, that the side vents are partially blocked, therefore not allowing enough air in through the sides to maintain the flame. Use a shop-vac or other strong suction vacuum to sweep along the side ...
Question about Noritz Water Heaters
side of the burner. If non of the above then try removing the flame rod and cleaning with 400 grit sandpaper or replace it with part order # SKC7448 (called an Ignition plug ELV & Packing EHK SETV
...side and put a new pilot assembly in one but can not get either pilot light to stay lit do you have any ideas. thanks greg Thoms hey greg. most likely its your flame sensors... right near the burner ...
...side of fitting where it attaches up near burner that needs to be cleaned out with paper clip or even better, compressed air. After cleaning burner, adjust air shutter to get nice blue flame, with ...
...burner shuts off after water is . finished heating and dosent continues to turn flame dose not maintain water temprature and flame shuts off dose not stay burning sounds like the gas valve is no good ...
1 questions posted
Usually answered in minutes!