Fisher and Paykel Aquasmart wl80t65c "machine control fuse" Questions

...FUSE IN PLUG AND FUSE BOARD NOTHING WRONG. SWITCHING ON AND OFF AND FUSE IN PLUG ALSO FUSEBOARD I am sure there is a electronic control board on the machine. I will bet the control board is

...control panel usually a SMPS unit. Use a multimeter to check for short, if so this must be replaced.check for tips from the link ...

...CCU control board cannot be replaced. Unless you would have a fuse that blew from age, replacing would not solve the reason why the fuse blew. A new one could equally blow when you start the

...machine model GWL 15 keep popping the fuse Hi I have a fisher and paykel washer machine model GWL 15 and I got a new motor controller (P7CPE) because the fuse inside of the controller blow on the ...

machine blew the MCB on the fuse board, the fuse in the plug is ok. There is no display when plugged in and the drum was still full of water when it stopped. Possible that the control panel had failed

...machine. We have replaced the controller but am still popping 2 of the 3 fuses. I have no idea where to go next... Please help... when you replaced the controller it was for the reason you stated, ...

machine but plug looks completly sealed.can you help please Hi just read your posting.Are you talking about the fuse in the motor controller?Is your model the US model and has a fuse in the plug?If it

...machine is protected by a fuse in the plug top...water pumps or drain pumps usually suffer from a damaged impeller...or damaged coil windings...either of would require you to relace the pump regards ...

Control/ timer not engaging. Think timer is bad but not sure how to confirm other than repair service. If your washer doesn't seem to work at all, check these: No power Lid switch No power Checkto see

...fuse supplied with the new pump. Now as soon as the machine is plugged in, the pump starts running and will not stop. Also getting diagnostic code 37. Your Motor controller board is faulty and needs ...