Question about Chamberlain Building Materials
I cannot figure out, where is the button on motor unit to change the access code.I have Whisper Drive 1/2 H.P Chamberlain. Check your manual or go on line and find out where it is. I also have the 1/2
I have roller door opener merlin430R. I can not find learn button!!! Is not the one with the green cover.... I have only 1 red button on 1 side that opens and close the door.. under lamp cover I can ...
...reset my remotes on my Craftsman 1/2 HP garage door opener. I first reset the remote from the SRT button on the GDO. I'm following the directions...hold button on remote, then push light button on ...
Question about liftmaster Building Materials
The wall button has a green light that is blinking and the car remote will not operate the garage door but the wall button works this just happened to us today as well. the wall pad has three buttons:
Question about liftmaster Building Materials
...to program my garage door to my truck..help please 1. In the vehicle press and hold the two outside buttons until the indicator light begins to flash (after 20 seconds). Release both buttons. Note: ...
...remote code. Program the Receiver to Match Additional Transmitter Codes: Using the orange "LEARN" Button: 1. Press and hold down the transmitter button you wish to program to the opener. The orange ...
Question about Building Materials
After connected to the power, the courtesy light flashed 2 times and the up and down button on then off. I pressed up, down and programme button, no respond. What should I do? It is likely that your ...
Question about liftmaster Building Materials
The remote opener reset button goes off and will not work There is a green reset button o the back of the unit and the green light has to be on in order for the remote to work. Once I reset the green ...
Question about liftmaster Building Materials
cant turn off lock button on craftsman control consol 53687 lost manuel cant disable lock button You need to hold the lock button for 3 seconds. If the green LED in the wall control is blinking off ...
Question about Building Materials
...Operation Using the Universal Remote System Press and hold the appropriate Universal Remote system button for at least one-half second. The indicator light will come on while the signal is being ...
185 questions posted
Usually answered in minutes!
2 Questions