Hayward 1 12 Hp Super Swimming Pool Pump Sp2610x15 "tripped high limiter" Questions

My tub keeps tripping the breaker, but after it kools down I can trip the breaker back on, but it hits 100 and trips the breaker again, could this be the heater? What Trips? the "Actual" electrical ...

motor hums but won't kick on pump hums and feels hot pool was over filled with rain water will pump pump come back on if cools down motor high limits tripping defective motor replace motor or whole ...

live in florida - pool pump goes off for a half hour and then turns back on and then operates normally for a while. it then repeats the same eequence. is this due to overheating it does sound like ...

When I turned my pump off to backwash and then turned it back on it made a humming noise then stopped running. Now it is doing nothing. what could the problem be? sounds like a bad start capacitor, or

...the pump motor and seal, should take care of the problem. The OH may have been caused by the pump not moving enough water to run the heater and tripped the heaters high temp sensor. I hope this

tripped the breaker. These motors have an internal high limit that shuts the motor downs at a certain temp.. Finding the reason for overtemp can be fun, check the wiring for looseness and for adequate

...HIGH LIMIT EXCEEDS 135F SPR = AUXILLIARY INPUT FAILURE ROL = ROLL OUT SENSOR TRIPPED SNS = TEMPERATURE BELOW 36 OR ABOVE 110F FFL = FALSE FLAME SIGNAL GCO + GVC = POWER TO GAS PV OR MV WHEN NOT ...

pump runs 3 mins turns off Sounds like the pump is overheating and tripping the high limit. If it reaches a certain temperature, the motor will shut down to save itself. This is usually from ...

I have a Jacuzzi laser sand filter. The system worked fine until I noticed that the circulating motor was extremely hot when running. The pump and motor were very old and in poor shape. So I replaced ...

pump keeps clicking on and off you may have a problem with supply power causing the motor to overheat and trip it's internal high limit. You could also be developing a short in the motor winding, ...