Mitsubishi WS-55511 55" Rear Projection Television "pico fuse" Questions

pico fuse what kind of pico fuse need sony tv model kp57ws510? They are usually 3.5 amp picos depending on what circuit they are in. If you go to this link and leave a email with your model number and

cant tune red bulb blue and green is in alignment,can get red aligned to the white cross. Check pico fuses F9A04 and F9A05 if either one of those picos are open it means the convergence Ics are bad ...

...pico fuse is bad on my circut board This can be tested with multimeter only, set multimeter on continuity and check pico fuse both pins, if meter shows zero ohms resistance that means pico fuse is ...

What are the specific pico fuses for my RPTV What are the specific pico fuses for my sony KP-61S65 i only found 2 pico fuses in my tv do anyone know the values of these 2 pico fuses PS602 1-533-597-31

...pico fuses look simular to resistors but are a solid color and has the value writen on it. the component location will start with "F" (Fxxx) or in some cases "PR" (PRxxx). F stands for Fuse and PR ...

...and see if its A KP46WT500 model? If so chances are just the convergence Ics ( stk 392-560 ) and pico fuses are the problem. There are 6 3.5 amp pico fuses directly beneath the heat sink fins on ...

...pico fuse in DFW area I have a 42" Mitsubishi HDTV that needs a 125v 5a pico fuse. Having trouble locating a local store in the DFW area to get parts. Does anyone know a source to get these parts? ...

...a wire on the FC connector and believed that I blew the F9A02 Fuse, part # 283P144040 (32V 15A). Thanks, Jim Tries Websites Tv repair World.com,Tvrepairkits.com and Ebay.com look for the pico

...pico fuse and they are still open. so they say it must be my ic yes when either of the two Pico fuses F9A04 or F9A05 fail its caused by the convergence IC. replace the IC and both pico fuses should ...

I Change the two stk for the convergence but steel have troubles most sony models require the 6 pico fuses on the D board and the 2 Picos on the G board will require replacement along with the two ICs