GE Spacemaker JVM1640SJ Microwave Oven "reset f3 code" Questions

...to beep the f3 message on the lcd, i unplug it then waited for good 10 min and reconnect it but the same problem. anything i can do to reset it? the code means this. F3Shorted touch pad panel Good ...

reset and will throw the F3 again. You'll know it's reset if the panel says Set The Clock. That saved me a repair and downtime. Joe From NJ Easy F3 error code fix = use your vacuum hose's suction over

...reset it, and the display now reads F3. None of the buttons work now. HELP! Anna I have the same problem. However when I unplug the microwave from the wall outlet, let it sit for 10 seconds, then ...

...F3--Shorted key panel(touch pad), will occur if a shorted key panel is detected continuously over 60 seconds.test the following:1. Door is not closed (some models). 2. You waited to long (open and ...

F3 Oven Sensor Open Check/Replace Sensor F4 Shorted wire or Sensor locate short and correct it or replace Sensor F5 Defective ERC Replace ERC F6 Problem with time keeping circuit Reset Time or cooking

...F3 indicates a failure of the keypad. The first thing to try is a "hard reset". Unplug it from the power line for a few minutes, plug it back in, set the clock, then try again. If that doesn't take ...

...F3 error code indicates that the keypad for the control panel is bad or has a short. This will cause the microwave to beep continuously after the set clock message appears. Unplug the power cord for ...

...F3 usually means a problem with the control panel. There may be a corroded component or a power surge damaged the unit. Sometimes a little water will get into the keypad and cause the problem. First ...

...F3 error code indicates that the keypad for the control panel is bad. This will cause the microwave to beep continuously after the set clock message appears. Need things    * ...

...F3 error code indicates that the keypad for the control panel is bad. This will cause the microwave to beep continuously after the set clock message appears.solution to the problem   1 ...