Honeywell HE360A1027 Whole House Humidifier Humidifier "turn down furnace" Questions

...turn it down? is it a faulty furnace? Hi!!! your fan blower has a capacitor right next to it change that first and test it.If sound is still there then your fan blower windings are getting bad..Good ...

...IT DOESNT BLOW ANY AIR IT WILL JUST SHUT DOWN . MOST OF THE TIME IT WORKS GREAT WHAT COULD CAUSE THIS? When I turn on my Oil Furnace after few minutes start smells to oil and then the smoke alarm

...turn it down the furnace comes back on.... It is possible you may have wired it wrong. Make sure your humidifer is not robbing power from your thermostat. This would explain when your humidifer makes ...

...small (1-2 cups) pools of water on the floor below the bottom of the return air plenum. Yes thats how it works If you think the flow is too fast turn down the flow , with the valve on the water line

...furnace goes on the air movement pushs the sail down inside the duct work that makes a contact the lets the 24volts to the humidastat. If the humidastat calls for moisture it turns on the humidifier ...

...small wires. but to change shut down power to furnace and water to humidifier.you loosen the 2 compression nuts unwire they cant be reversed so dont worry then 2 mounting screws then reverse to ...

...furnace. I have a different contractor who installs Aprilaire products and who has been fixing lots of issues with the unit since its install, i.e. replaced fan motor, humidistat, and, in an attempt ...

...Depending on were youre humdistat is mounted either on tha return duct near the furnace or on the wall in the living area this should be an easy fix turn the dial down there is is to much

...turn it down. The wires for the solenoid should be hooked up to your furnace circuit board. The instruction manual will tell you where. If you dont have a spot on your circut board the A 50 sensing ...

turn on and off with the blower motor of the Furnace. This can be done by wiring the the humidifier to the HUM terminal on the furnace control board and then stepping down the power with a transformer