Question about Black & Decker Tools & Hardware - Others
screws loosened turn unit face up with bottom toward you and gently pry bottom apart. There are wires and tubes connected inside so just prop it open enough to work. Replace battery ($29 + shipping on
Question about Culligan Tools & Hardware - Others
...work it up carefully so you don't damage the cable connection. It is potted for strain relief, so shouldn't be a problem. After the top cover is clear you will have access to the ...
Question about Poulan Tools & Hardware - Others
What is H and L carb setting for a Poulan P3314 It is a new chain saw just about 2hrs runing time i try to get a better performance by playing with L and H adjustment screw and the idle screw and i ...
...to know how to adjust the flatness side to side on a dw733 dewalt planer. You have to loosen the screws on the blades and adjust them. It tells you how to proceed in your owner manual having spent ...
Question about York Tools & Hardware - Others
my york diamond 80 can be fired up, but it is shut off automaticaly after approx. 20sec. This can be repeated 3 times. I beleive the fun and borad panel are working fine. The flame sensor might have ...
Question about Dremel Tools & Hardware - Others
Is there a specific tool recommended to loosen the set screw so I can change the tip? It doesn't mention anything in the directions Engraver Kit / Model: 290-01 - Dremel.com www.dremel.com/en-us/Tools
screws from the hardware store may not work. Take the plane to a genuine hardware store where someone will help. There are typically 2 slotted machine screws that secure a frog to the plane. The plane
what kind of tool do you use to adjust. they have a tool for that crappy little hole you have to get to adjust the idle screws. Or u can use a deep socket same size that work's also
my old dremel engraver does not work Have you tried changing the bushings. These are located inside the screw looking pieces. There are usually one on each side and these can be purchased at Lowes. If
Question about Kreg Tools & Hardware - Others
...jig, jointing 3/4" boards-hardwood red oak, generally works great, but about 20% of the time the screws are not locking down and instead just keep turning and boring out the shaft. What is causing ...
126 questions posted
Usually answered in minutes!
36 Questions
9 Questions