...or you will also need to get a PP1 programmer to reset it for your chair. If it came off of any RWD chair and the connections are the same, it will work on your GO-GO. hi my chair wont switch ...
...batteries in You will need to get 2 U1 batteries for your chair do not get Wally World or automotive batteries You must replace with sealed deep cycle batteries made for power chairs Hope this ...
...need to charge the chair at least once a week and always put it up fully charged. Once the batteries get weak then no chair charger will pick them up. Check with a local battery warehouse or similar ...
...When in gear you won't be able to push it. Just because the lights are coming on does not mean the batteries are good. If the chair has been sitting for a while you'll probably need to replace
...getting too hot or the chair has a lift on the seat. If the chair runs fine for a while and then this condition appears, you may have a bad motor or a brake dragging causing the motor to get hot. the ...
...red. Then after turning the chair off then on I get more green lights. The battery is 3 yrs old. Could it need to be replaced? Yes prob one of the batteries are bad, but you may want to replace
...the front of the chair to get it out of the back tabs. Before you start you need to unplug the joystick from the base. The chair is heavy and awkward. It is best you have 2 people removing the
...grade. Also, most chairs have a tilt sensor in them that will cut the power if the chair is too inclined. Getting it level again, turning off and restarting after a few seconds should do the
Question about Pride Health & Beauty
...need to add high powered head lights. How can I accomplish this? The best way is to get a 12volt battery separate from the chair itself, harbor freight has some nice systems. The chair is 24volt and ...
89 questions posted
Usually answered in minutes!
42 Questions
27 Questions