Super glide 120 E4 code. I see nothing that should cause this @
Hi, Sandra for this scenario you will need your service manual that has all fastener torque specs -fluid capacities and a wiring diagram on the back pages, parts fiche, and owners manual if you can not find the best tool you ever bought for your Harley, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below and for more specific information or questions at no charge please feel free to contact me at [email protected]. Good luck and have a wonderful day.
https://www.thunder-max.com/techdocs/HarleyDiagCodes.pdf
http://www.mediafire.com/file/65e9i0e80baqvhz/Harley-Davidson_Dyna_Service_Manual_2003.pdf/file
https://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
http://mybikemanuals.com/harley-davidson/harley-davidson-dyna-glide-owners-manuals/
https://www.6ya.com/how-6ya-works to speak to me personally.
SOURCE: change a stator
First secure the bike on a lift. disconnect battery.remove standard footpeg.Remove standard shifter. Remove all allen head bolts from outer primary cover. Some bolts are longer so keep track of where they go.Two bolts on the primary inspection cover also hold the outer to the inner primary case, so remove the cover.Now remove the outer primary case.The clutch,primary chain,adjuster, and compensating sprocket must be reoved as a single unit.Once you have done this take a rag and grasp the rotor and slide it off of the main engine shaft.Unplug the stator and remove the set screws holding it in place.Reverse procedure to install new stator.
SOURCE: change a stator
First secure the bike on a lift. disconnect battery.remove standard footpeg.Remove standard shifter. Remove all allen head bolts from outer primary cover. Some bolts are longer so keep track of where they go.Two bolts on the primary inspection cover also hold the outer to the inner primary case, so remove the cover.Now remove the outer primary case.The clutch,primary chain,adjuster, and compensating sprocket must be reoved as a single unit.Once you have done this take a rag and grasp the rotor and slide it off of the main engine shaft.Unplug the stator and remove the set screws holding it in place.Reverse procedure to install new stator.
SOURCE: will the gas tank and wheels and fenders off a
I believe they could. Possibly not the fenders, but the tank, that's a probability. Check the mounts, and take some measurements of tank length on the bottom.
Testimonial: "thanks hut my bike is in a harlet storage shop for the winter and if eveything fit I was going to by the parts and have them install them during the w"
SOURCE: how to change oil in 2003 HD FXD Dyna Super Glide
remove the drain plug from the oil pan, you will need either a 3/4" box wrench or a 5/8" box wrench and the drain plug will be facing forward on the the oil pan. It is easiest to remove this drain plug from under the right side of the bike. put drain plug back in after about 10 m,inutes of drain time and tighten to 18 ft. lbs. Dont forget to change the oil filter as well.
SOURCE: Will the wheels from a 2000 Harley-Davidson FXDX
Check to see if they both have the same diameter axle. Harley went from a 7/8 inch diameter axle to a 1 inch diameter axle sometime around that time period.
154 views
Usually answered in minutes!
×