2007 HM CRE F490X I Logo

Related Topics:

Anonymous Posted on Nov 10, 2008

SPLUTTERS AND DIE

My F490XI model when i start it the bike splutters then dies it has a bad noise from the right side of the topend iam putting in a new cam chain did the valves that did not get rid of the noise also putting in new cam shaft bearings as they are loose can anyone give me am idea of what the problem is the carb seems fine all the tubes dont leak ive put a new spark plug in to

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

  • Master 2,712 Answers
  • Posted on Nov 10, 2008
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

Joined: Aug 07, 2008
Answers
2712
Questions
1
Helped
724298
Points
8771

First what kind of noise. Plus did you replace the cam chain tenisor when you replaced the chain. That will make a noise in the top end. Other than that piston slap will cause some noise but you will hear it more at higher rps most of the time. I have seen a lot of problems latly where the tank does not breathe properly so it will start spudder then die a few times. Usually it is the gas cap.,

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Hi there . I'm having problems with my 1997 Opel corsa utility . It starts and idle smooth but after about 20 seconds it splutters and die , if I press the petrol it starts to splutter and die . Usually it...

I'd guess: not enough fuel flow. could be a fuel filter, fuel pump, fuel pump relay, fuel pressure regulator. No check engine codes? I would think there should be some that would help diagnose.
1helpful
1answer

Cuts out and splutters will start agai after a few minutes then will do it again

yeah had the same once on a tzr 125 4dl would ride for a short time fine then splutter and die after a couple of mins would start fine and do the same again .. it was the breather on the fuel cap . if blocked causes a vacume stopping fuel from flowing . once cleaned was all fine
1helpful
1answer

I have a YAMAHA TDM 850 1997 and when the main fuel runs out and I have to turn the tap to reserve the bike dies and will not start again until I have pulled the fuel pipes off to let some fuel/air out and...

Not 100 % sure but I would take the fuel select valve out and clean it. It sounds like you have something blocking the valve opening. Since it is the side of the valve you don't use all the time it can gum up.
0helpful
1answer

I have a fresh motor, new topend, starter gear?

Check the plug. I have had a very similar problem just recentley yesterday infact. It could be that you are running the oil mixture too rich as well...Good luck
0helpful
2answers

Engine splutters and dies when i try to turn it on

sounds like either the cam or crank sensor is going bad, test both and get back to me
3helpful
4answers

I have a pit bike and it splutters alot when i ride it

my pit bike will not keep it revs for a long time so can some one help me it is my first pit bike
Not finding what you are looking for?

169 views

Ask a Question

Usually answered in minutes!

Top HM Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66980 Answers

Are you a HM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...