Toyota Camry Hybrid - Answered Questions & Fixed Issues

Question edited for clarity. Question moved to model category.

2010 Toyota Camry Car Stereo Wire Guide - MODIFIEDLIFE

https://www.modifiedlife.com > 2010-toyota-camry-car... Our 2010 Toyota Camry radio wiring diagram shows you all the 2010 Toyota Camry radio wire colors and what they do. Use our 2010 Toyota Camry stereo wiring guide ...

How To Toyota Camry Stereo Wiring Diagram - My Pro Street

..

SEE YOUR DEALER WE DO NOT KNOW THE PART NOR THE NUMBERS

Try disconnecting battery for a few minutes then hook it back up. Seems to make the console reset and reboot. Worked on my 2009 Camry. If that doesn't work then it could be a loose or dirty connector. Good luck

caused by the power steering pump, a small price to pay to pay for light steering at slow speed. you'll find most cars with steer assist tend to make some additional noise when the pump is being called on.... if the pump is faulty and eventually gives in, the worst that'll happen is being stubborn (heavy) to turn slow corners or while parking.

Here is the recommended maintenance for your car http://www.driverside.com/service-schedule/complete/toyota-camry_hybrid-2009-23545-31396-57629

driving a car with no water in the engine generally causes major engine failure as from your description the dealer will only fit new engine so find an accredited service center who has experience on your make of car get quotes to fit service exchange engines from reputable engine reconditioner or good engines from wreckers or junk yards You can get good rear ended write offs where the engine has not been affected and has low miles on the clock

It is part of the main engine control computer.

this is a common problems among cars, it just happen toyota got alot more sticky melting problem. your solution is in the youtude under treatment for sticky melting solution.

Use some WD40 on it.

It could have something to do with the regenerative power system. When you apply the brake in hybrids, it redirects energy from the braking system back into the charging system. It could have a battery issue. or The transitional system from the electric to combustion drive could have some intermittency. But, with hybrids, you really need to have it checked out. If there is a battery problem, it could cause a lot of damage. Sorry I could give a more solid answer. I'd need to know more symptoms of the car while driving.

Owners manual should tell you.

use needle nose pliers

hi . if the abs light is on its usually a sensor that's gone down.if so will need to be changed. before light goes off. after reset.

Chevy suburvan trucks will fill the bill.

No idea but if your in the EEC then this vehicle should not have been re-registered as it has no europeon certificate of homoglonation for the europeon market ,even in the Uk which is so lax about paperwork that it needs some spanish beurocrats to put it in line regarding paperwork ,like identy cards with fingerprint and photo on ,X in front of the number to identfy non nationals and a goverment policy to only employ british nationals in all govermental posts and not this silly positive discrimination in favour of imigrants .Opps musnt sound like a right wing extremist but i am only stating the true facts about living in spain

window may be stuck push down on glass and try letting up and down at same time

Disconnect the neg.side of your battery for about a minute and that should reset the computer.

on ice?

see the operators guide, in glove box. read it. if it shows you how to do it. bingo, if not , like many newer cars, there is no dip stick tube. (google that many hits) and has a side plug, and is now covered in the FSM , in the tranny section. If doing DIY and are serious,. buy the FSM or at the very least this. http://www.fixya.com/answer/answerpageslideview.aspx?ctg=231&fml=0&brd=1071&thid=22401256 what do we, do, we open the hood and look. simple check its there or not, if not sure, look at side of tranny see any dip tube.,? Y/N BINGO. btw, some years, 1/2 are and 1/.2 are not. so, looking works.

the brake light is stuck on? its covered in the operators guide. fluid level good?DOT 3/4 brake fluid? hand brake really off? if ok that, read the FSM it covers this 100% or take it to any ASE mechanic. the newer the car , the more ways to fail. The ABS may be on , due to brake failure. fix brake lamp on reason first. may be they are bad. the brakes, get the car scanned , to find all errors, i bet there are more. only a real shop has all the tools to do ABS, and brakes.