Stalling, dying,rough idle. After engine warms up, engine will start, but will not idle, dies. check engine light on.

Ford Windstar Starting/Stalling Problems - Car Forums at Edmunds.com

forums.edmunds.com > Ford > Ford Windstar

Oct 16, 2007 - 31 posts - ‎26 authors
Learn more about Ford Windstar at the Edmunds.com Car Forums! ... I tried to startmy van on a 15 degree morning - heard a loud bang and now it won't start. Battery ....The engine will crank, start run about 5 seconds then stop. ... I have a 2003 Ford Windstar, same problem,Ford is covering up the problem.

Why My Car Won't Start? - Reasons and Solutions

www.myautorepairadvice.com/car-wont-start.html

As a rough guideline, problems with the battery, alternator and starter are the most ...Before I even put the key into the ignition I hear a clicking noise on the right side ...started it and then it started making a loud clicking noise while I was driving it ..... i have a 2003 windstar ford it was clicking and wouldn't start had to get a ...

Rough Idle Engine Dies Loud Ticking!?! Please Help! - Ford Focus ...

www.focusfanatics.com/.../103146-rough-idle-engine-dies-loud-ticking-...

Nov 6, 2006 - Rough Idle Engine Dies Loud Ticking! ... down then dies and then i restart and it has no problems but the ticking continues PLEASE HELP ME ... Level Up0% Completed ... 2. my injectors are bad and the ticking sound is one of the injectors.... Another method is to turn the AM radio on to a place where there ...Missing: windstar

check vaccuum pipes may be at fault and need replacing.

I guess I will start with asking why you changed the crank sensor and the TPS ?
Usually when the engine is stalling at stop signs the problem is a dirty throttle body or a problem with the idle air control valve.
If the check engine light is on it should have a code unless the PCM is failing. I would try another scanner next to make sure the computer does not have any trouble codes.

A stalling problem doesn't have to turn on the check engine light . Try some basic thing's like cleaning the throttle plate (body) air passages for the IAC - idle air control valve . There are videos on youtube , also check for a vacuum leak !

Cleaning Throttle Bodies
Throttle Body Cleaning To Restore Idle Quality

it could be u needd new spark plugs and the sparks or the timings offf change sparkplugs and plugs and ur gasfilter tat sud do it .

remove dog house locate test port and install guage should be 45-60 psi

try the control module

Check engine codes.
If it comes up as a Crankshaft sensor... Replace it.
These are the exact symptoms

Check and clean the IAC valve. Idle Control Valve. Use brake cleaner or carburater cleaner . Remove the duct work from the air filter assembly. It is located just inside . Run the engine at 1200 rpms and spray the valve. The valve can also be removed and cleaned.

sounds like its not accident related, more like a idle air control motor or something of that nature, ive also herd of this happening when the crank sensor is going bad, it warms up and starts missing the signal.