How do you change cabin air filter? Have removed cover under glove box, but can not find air filters on 2003 tahoe

The air filter may be a slide in type just above the fan motor and it may have 2 screws to gold it in place . Check with a workshop manual

Yes there is. It is under the dash on the passenger side of the car. Just under the glove box. There is two screws holding it in place. You will see a strait line on the heater box and it is behind it.

If you are talking about the cabin air filter, this filters the outside air for the HVAC.
Hastings Filter (#AF1057) shows one for the 97-03 MY trucks.

Remove the screws that hold the horizontal filter housing cover from behind the glove box (no need to open the glove box);

Pull the cabin filter straight down (sits vertical behind the glove box inside the housing).

Install replacement and reattach the cover.

The cabin air filter is usually located behind the glove box or at the base of the windshield in the cowl area over the HVAC inlet duct. The exact location can be found in the vehicle owner’s manual or a filter reference guide at the auto part store where you purchase the cabin air filter from.
On most Fords, the filter is located under the hood in the cowl area. On Chrysler models, it is located under the dash. On GM products, it might be under the hood (Impala, Lumina and Monte Carlo), under the dash (Avalanche, Silverado, Suburban and Tahoe) or behind the glove box (Venture). On Toyota, Lexus, Nissan and most Honda models, you’ll find the filter behind the glove box. There is no cabin air filter even listed for a 1998 Oldsmobile Regency.

On vehicles where the cabin air filter is mounted under the cowl at the base of the windshield, some disassembly may be required to replace the filter. This may involve removing a plastic cowl cover. The area around the filter usually collects debris, so this area should be cleaned to remove any leaves, bugs or other debris before the old filter is pulled out. This will prevent any contaminants from falling into the HVAC inlet duct.

On vehicles where the filter is located behind the glove box, the glove box may have to be removed to replace the filter. On others, the filter can be accessed from under the dash and pulled out of a slot in the HVAC unit.

Most cabin air filters are flat-panel filters, but some have unusual shapes, so they will fit the HVAC inlet duct. Some filters also come in two sections to make replacement easier.

at the bottom of air box there is a strip about an inch wide with a 7 mm bolt attached at the bottom near firewall remove bolt and strip and you will see filters

Open glove compartment. Press inward at both sides of the glove compartment, then lower the glove compartment.Remove the lower side instrument panel and crash trim pad. Remove the four glove compartment upper cover retaining screws, then the cover. Remove the two glove compartment retaining bolts, then the glove compartment. Press on the cabin air filter cover tab, then remove the cove
Remove the cabin air filter from the blower unit opening. Install a new cabin filter, ensuring the air flow marking is facing in the proper direction. Install the cabin air filter cover, ensuring the cover is properly installed.
Position the glove compartment to the instrument panel, then install the two retaining bolts. Install the glove compartment upper cover. Install the lower side instrument panel crash pad. Lift the glove compartment into position. Close the glove compartment.

The Cabin air filter is located behind the glove box, There is a plastic cover that must be removed to change the filter, if the filter has never been changed a plastic bracket may have to be removed also.

Yes. It's under the glove box, behind the plastic cover. On the very bottom ther will be three screw (7mm) take those out next there will be a thin plastic cover that has another 7mm screw in the back towards the firewall. The filter will slide staight down, and there are two. Slide the first one out then slide the second one out.

I have an 06 corrolla. Open the glove box, empty it out, and on both sides you will find philips head screws holding the supports. Once removed the glove box will tip forward and expose the cover of the cabin air filter. Carefully remove the cover and pull out the filter.(note the directional arrows of the filter as you remove it) Installation is a reversal of the above.

cabin air filter is under the golve compartment or under the cowl vent cover / Please rate my response thank you very much