Hello spitandspat,
Here is a step by step. As always care must be taken when lifting a car, proper support is necessary.
The starter is on the side of the engine closest to the radiator.
1. Disconnect the battery negative cable and isolate it so it can't make contact with the battery connection.
2. Raise and properly support the car.
3. Disconnect the wires from the starter.
4. Remove the plastic shield from the bell housing to expose the starter bolts.
5. Remove the starter.
Note: If there are shims under the starter you will need to replace them as needed.
Note: Compare the old starter with the new starter before installing are two different starters for this application.
Installation is the reverse of the removal.
Regards,
netvan
1,712 views
Usually answered in minutes!
×