Having problems with turn signals as well as hazard light not working properly ,we change turn signal switch as well as fuses. THIS IS 1997 OLDS REGENCY 3.8

The linked video is for the 1996 Pathfinder .... I think Nissan changed the fuse map layout for your 1995. Regardless, you look for the 7.5amp fuse labelled "Turn Signal"
HOWEVER ... the wiring of the turn signal on this car is shared by the hazard warning light switch wiring. So if your turn signal does not work but your hazards do ... it could be something other than just the 7.5a fuse ... the part of the hazard switch that is shared with the turn signal wiring could be bad ... which kills your turn signal but lets the hazards work. Also ... if the fuse is good and the hazard switch is good then it could be a wonky combination switch (turn signal switch) off the steering column.

Sometimes the housing the bulb is in has gone bad try cleaning out the prongs where the bulb goes in it that does not work replace the fixture the bulb goes in had the some thing happen to my trailblazer hope this helps

The first place to start are fuses, check your owners manual for location, typically left side of dash.

The emergency (hazard) flashers and turn signals are on separate fuses and run through the hazard switch. If all the lights work when the hazard switch is on then the problem will likely be a blown turn signal fuse.

Other possibilities are the hazard switch itself is bad, the turn signal switch is bad or a broken wire, all of which require a meter (or test light) wiring diagram and knowledge of the circuit to test it - better to have it done.

Robert Grove
Mobile Mechanic Malibu 310 651 8020 Auto Truck RV Mobile Repair...

Hazard switch..had it happen to my 2002 impala

The hazard switch gets power from the horn fuse which is hot all the time, and from the turn signal fuse which is hot when the key switch is on. The turn signal switch gets power from the hazard switch and both use the same flasher.
So if the turn signals work but the hazard switch does not power the lights, and both fuses have power, I would say the problem is inside the hazard switch.

I need one new hazard switch for my hyunday sonata 1998 4cilinder

you don`t say but do the lights work either on the front/back on both sides.if not then it may be a fuse that needs replacing or need a bulb replacement.if the lights work but don`t flash then it sounds like a signal flasher problem.the flasher is located in the fuse panel under the dash on the drivers side.if the hazard flashers work then turn them on to find the hazard flasher by the fuse panel then you will know what the signal flasher looks like and change the signal flasher.make sure you change the one for the signals and not the hazard one.if the hazards work then i would say the signal switch is good as the hazards work through the same switch.

You changed the hazard flasher or the turn signal flasher? It has two, one for the hazard and one for the turn signals

the hazard switch above the radio is your problem. if you put on your signals and they don't flash turn hazards on then off and they will flash. (changing this *** will fix your problem

check the flasher and the fuse