For the carb :
Idle r/min.- 1550+_50 r/min.
fuel level- 4.5+_5.0 mm
float height- 25.8+_1.0mm
pilot screw- 1-3/4 turns out
do you need jet #'s or not?
the "+_" signs are those plus-over-minus signs i cant do on my comp.
Valves:
valve diameter- in-30mm
ex-26mm
valve lift- in-5.5mm
ex-5.5mm
valve clearance or tappet clearance (cold):
in & ex: .08-.13mm
valve guide to valve stem clearance:
in-.010-.037mm
ex-.03-.057mm
valve guide I.D.: in & ex-5.5-5.512mm
valve stem O.D.:in-5.475-5.490mm
ex-5.455-5.470mm
Hope this helps.
SOURCE: what is the standard valve clearance and ignition
Hello! Valve clearance is the same for the 1.5L and the 1.6L
INTAKE= .001"- .002"
EXHAUST=.002"- .003"
See diagram below to locate Yellow rubber cap covering the ignition timing plug...It is located under the right side of the dash...Wire colors are: Brown and Green/White...Short these pins together...Start the engine and allow it to reach normal operating temperature...
TIMING= 16 TO 20 DEGREES BTDC @700 RPM
Guru................Saailer
I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867
654 views
Usually answered in minutes!
×