The heater plugs in my hyundai tuscon but can't seem to find them have looked in the usual place
First open the bonnet then remove the round cover on the back of the lighting cluster {its like a jar top} then remove the wiring to the bulb ..then carefully undo the spring clip that hold the bulb in place {as in most cars} its a bit fiddly but its like a spring clip that is fixed at one end then goes over the terminals to a little space on the other side of the terminals {you will see what i mean when you remove the ;: jar top ;; then gently remove the bulb ..it may be a good idea to upgrade now to high out put bulbs {available from many motor factors} when refitting always wear plastic gloves {to avoid getting moister from your hands on the glass envelope of the bulb ..any moister will shorten the life of the replacement bulb if you do put moister on the envelope of the bulb clean of with a none oily spirit } now refit the new bulb {it only fits one way then the tricky bit refit the retaining wire this can be easy or a pig to do ! once you are happy that the replacement bulb is home OK then fit the cable and them refit the jar top .then teat ..good luck ..the batter side is the hardest ..it may be worth removing the air intake hose ..if you do this ..its just two press screws with plastic plugs its east to remove and re fit there is no need to remove the battery
STRAKER1999
463 views
Usually answered in minutes!
keep getting "not ready" message during E-check. Need to know how to complete drive cycle
×