The headlights on my 2000 Toyota Celica GTS both stopped working at the same time. The high beams / brights still work though. I have checked the 10A fuses in both the larger fuse box and smaller one under the hood. Are there any other common causes for both to go out at the same time?
The globes filament for low beam are most likely both blown . Check if the plug is getting voltage when the low beam is on or buy a replacement globe and check if this is the case.
How do you know both low beams stopped at the same time ?
They most likely blown at different times but you notice it when both go out and you have zero light. Had this happen to me on a ford falcon EA . Was the globes.
Try not to handle the glass on the replacement globes if Halcyon globes .
SOURCE: Low beam headlights do not
most cars have a fuse or relay for high and low. if they are good test your bulbs then check or replace your dimmer which is in the multifunction switch
SOURCE: Headlights
I READ ONLINE THAT THERE WAS A RECALL ON THIS YEAR AND MAKE, CHECK WITH TOYOTA WEB SITES TO RECTIFY YOUR PROBLEM
SOURCE: Headlight 2004 camry
your module in the steering wheel is faulty you should get it replaced. you can purchase it at ie Napa for alot less than through a dealer.
SOURCE: 2001 Toyota Celica GTS Clutch
i paid a friend to do it because it's a lot of work! if you haven't already treid to or got it done just know that when my friend did it; it took him like 8 hours (he'd never done one on a celica, but had done them on american cars) so if your not familiar with it... not a good idea to do alone. I watched him do most, but i'm not the best to talk to about it.(plus i have a 2000GT) Some of the parts that i can remember that he took out to get to the clutch were the front driver's side tire, the axel on the same side, ....some other parts in there....and ALSO parts on top...the intake also had to be taken out just to have enough room to do the job. parts are cheap...just ask for a clutch kit at auto zone or whatever. around $150. another random tid bit that might help is make sure to tighten the engine mounts really good afterwards or else it will jump around in there when you turn it on and cut it off. buy gear oil before you start as well because you will need to put some in after the new clutch is in. i will need to put the car on a real lift... you need a lot of space underneath and on top to work. and most likely two people. well hope some of this helped.
SOURCE: 1985 convertible celica fuse location
Check the harness connections located inside r-rear trunk panel. You will find power top motor & wire harness there.
1,204 views
Usually answered in minutes!
×