Need to remove lock actuator, front passenger door, 1999 Odyssey

If the lock button doesnt move look like you door lock actuator jam you have to find a way to move the rear panel by the inside and unlock it manualy

Pop off the door panels & remove the plastic film. There's a white plastic actuator attached to the lock. You can test for voltage from the connector, but unlikely that's the problem. My symptom was the actuator was moving but not actually locking. It turned out mine was loose and I fixed mine by just reattaching the actuator. There's several screws holding it in there and mine came loose. Use lock-tite because it came loose a second time. If the motor isn't functioning then if you disassemble the actuator you might be able to search on EBay for a motor - the rear tailgate uses a Mabuchi. Otherwise you will need to replace the actuator. The rear one is about $80 online.

See this:

Honda Power Door Lock Diagnosis Actuator or Passenger Multiplex Computer

How to replace Honda Odyssey sliding door lock actuator

Personally, "I" would access the Latch Actuator and unsnap the electrical connector.

Next use a OHMMETER to test if the COIL inside the body to assure it's good!

100% OPEN = BAD
6 OHMS (or so) =OK!

Honda Odyssey 2000 power door problems

Anthony!

door lock actuator might be faulty or bad electrical contact
take off the door panel and diconnect and reconnect the wiring, you might need to change door lock actuator

1999 Ford Explorer Door Lock Actuator
REMOVAL:
1.Remove the front door trim panel.
2.Remove the water shield.
3.Remove the power door lock actuator.
4.Disconnect the electrical connector.
5.Drill out the rivet.
6.Disconnect the actuator rod.
7.Remove the actuator.
------------------------------------
Attached images

YES I HAD THE SAME PROBLEM I FIXED IT BY REMOVING DRIVERS DOOR PANEL AND FOUND ACTUATOR OUT OF LINE AND WIRE CONECTORS WERE BROKE I COULD NOT FIND REPLACEMENTS SO I USED WIRE ROPE GRIPS I ALSO FOUND LOOSE CONECTIONS IN WIRING I GOT CENTREL LOOKING WORKING AGAIN, HOPE THIS IS HELP.

SECTION 501-14A: Handles, Locks, Latches and Mechanisms 1999 Villager Workshop Manual REMOVAL AND INSTALLATION Actuator —Power Door Lock, Front Removal

1. Remove the front door latch. For additional information, refer to Latch—Front Door .

1. Remove the power door lock actuator from the front door latch.
   1. Release the locking tabs.
   1. Remove the power door lock actuator from the front door latch.

go here too

http://groups.yahoo.com/group/villagerquest/

the little motor that operates it inside the door is probably frozen, so it will need to be replaced!!

try just replaceing the drivers actuator first....that should take care of it