Derrick Schultz, for months, is a spammer on FIXYA, permitted to post the same post infinitely for some unknown reason. Seems to work with another spammer account, YoYo. Unknown if in coordination with Indian spammers that have been posting for months their repetitive spam.
SOURCE: BMW E90 323I, ABS resetting.
hey hassa, if you swapped an ABS control unit from another vehicle, it needs to be coded to your vehicle. If your vehicle does not recognize the replacement vin, it will set a fault. also, make sure to have the ABS sensors calibrated after the control unit is coded. most dealers charge about 1hr labor to perform coding and sensor calibration.
SOURCE: 2006 BMW 325i E90 remote programming
That remote you purchased, did you remove your vehicle key from your old one and insert it into the new one? At the back of the remote there are pinch grips, pinch and pull to remove the key, you should have a plastic version of this key for your car, in the spare in the glovebox, unless it has been removed, check also in the owners manual folder, if you bought this car used it maybe in there. If you do not have the kaey that matches your car to put in the remote it will not program to the car. Hope this helps, let me know.
SOURCE: bmw e90 fuel
YOUR BATTERY SAFTEY TERMINAL MOST LIKELY BLEW (ON POSITIVE BATTERY CABLE ON RIGHT SIDE OF TRUNK). NEEDS TO BE REPLACED. SEE A DEALER.
SOURCE: Where can I find a BMW E90 Workshop Service Manual
if it was me i would check with my local library or check on E-Bay wish you the best of luck Michigan Man.
SOURCE: how to reset service light for BMW e90 320i in
This is for 2001 onwards :
- Iginition OFF (POS 0) with key in.
- Press and Hold the trip odometer button while turning key to position 1 (ACCESSORY)
- Keep the button depressed (about 5 secs.) until you see "Oil Service" or "Inspection" with "Reset" or "Re" in the display
- *Note: On vehicles with "High" cluster, you will also see the amount of fuel (in litres) remaining until next service
- Press the button again and hold for approx. 5 secs. until "Reset" or "Re" flashes
- While the display is flashing, briefly press the button again to reset the Service Interval. After the display has shown the new interval you should see "END SIA" for about 2 secs.
Note that if the "Reset" or "Re" does not flash, then you have not met the minimum consumption level and cannot reset.
You can find more information at:
http://www.bmwtips.com/tipsntricks/reset-plug/reset.htm
189 views
Usually answered in minutes!
×