I am trying to find a video that shows how to replace the Front Bumper Cover on a 2002 Subaru Outback H3.0. Can anyone refer me to a video that shows how to do this? Thank You

SOURCE: fuse box location on 2002 Subaru

my books say there are two. one inside vehicle on drivers side below dash to the left of the steering wheel. the other is in the engine compartment on the drivers side by fender

SOURCE: replacing front bumper on 1999 buick regal

7/16th or 10mm Sheetmetal nuts All over Behind the Bumper Thak Bumper off first

SOURCE: Replacing a/c hoses in Subaru Outback 2004

give this website a try its about A/C-repair www.directgardening.com

Brandon Johnson

• 253 Answers
• Posted on Aug 09, 2009

SOURCE: Power steering pump replacement for Subaru Outback

REMOVAL

1. Remove ground terminal from battery.
2. Remove pulley belt cover bracket.

1. Loosen lock bolt and slider bolt and remove power steering pump drive V-belt.
2. Disconnect connector from power steering pump switch.

1. Disconnect pipe C and suction hose from oil pump. CAUTION:

• Do not allow fluid from the hose end to come into contact with pulley belt.
• To prevent foreign matter from entering the hose and pipe, cover the open ends of them with a clean cloth.

1. Remove bolts which install power steering pump bracket.

1. Place oil pump bracket in a vise, remove two bolts from the front side of oil pump. CAUTION: Do not place oil pump bracket directly in the vise; use soft pads and hold oil pump lightly to protect the pump.

1. Remove socket from oil pump.
2. Remove bolt from the rear side of oil pump.

SOURCE: the serpentine belt broke on my2002 subaru outback

There is a distinct possibilty there is engine damage caused when the belt broke. It is best not to turn the engine at all once this happens. Sometimes you can be lucky and there be no damage. Let's hope that's so in your case. These belts are supposed to be replaced every 100,000km.

Download instructions from my website...

http://arraw.info/pdf/Timing Belt.pdf