If you have separate heat/cool selections for the driver and the passenger, you have two blend door actuators, otherwise just one. You also have a mode door actuator, a recirculating door actuator, and possibly a defrost door actuator.
SOURCE: Blend door
ok first put you front seat down and back raise steering wheel . now lay on you back with you head in the drivers floor board. look up see 2 screws remove them and the panel they hold on . look to left main wire harness needs to be moved to the right , up and behind it is th blend actuator 7/32 socket to remove it then manually turn the white peg , total labor 30 min
SOURCE: cold air on passenger side warm air on drivers side
Actuator motors either get a tear in the rubber or a hose is broken and not letting vacuum assist in its opening.
You can try moving the lever by hand and see if the air gets colder on the bad side.
SOURCE: blend door actuator needs replacing does the
no it doesnt ... check out heatertreaters.net if you have to replace the blend doors .... but the actuator is directly behind the glove box...remove the glove box take out 3 screws and remove actuator and replace.....waa laa
SOURCE: What do I have to remove to access blend door actuator
very lenghty process. too long to describe here....go to Bonneville Forums read the text and follow linked there at the bottom....very good and detailed....I'm doing that right now,,,,it is a bugger,
1,806 views
Usually answered in minutes!
×