We bought a dipstick for a 2011 dodge nitro it measures in centimeters how many centimeters should a full automatic transmission have

If you mean the Air Conditioning and its compressor, yes it does. Press CTRL+F and type 'air'.

Fuse Box Diagram Dodge Nitro (2007-2012) - Fuse-Box.info

https://fuse-box.info > dodge > dodge-nitro-2007-2012...

2011, 2012 - The Integrated Power Module (IPM) is located in the engine compartment near the battery. This center contains cartridge fuses, mini ...

Hello Sarah,

You shouldn’t need to add transmission fluid as most Dodge products of this year had no maintenance transmission with no dipstick.

Did you have to remove the pan, or are you losing transmission fluid?

Pull Back The Little pulley And Take It Off

What codes do you have?

Why would start installing parts,
until you diagnose the codes &
actually find a problem?

gears are going out

Hey guys I have a 2011 Dodge Nitro 3.7 and today my engine light came on and it was running like I was on rumble strips. I floored it and it sputtered and ran terrible then the light started flashing then I cut it off tried to reset still the light came on. I put the scanner on it and it turned out to be the coil plug on the #3 cylinder. COIL PLUG. Hope this helps out GOD BLESS!

Start with 3 quarts, then add until it just touches the end of the dipstick, run the engine until the ATF is hot to the touch and then top off to the marks between high and low..

The transmission fluid goes in the same tube that holds the dip stick that you check the fluid levels with. You will need a funnel, and be sure to use only manufacturer recommended fluid in your vehicle. Be careful not to over fill. Ensure the Galant is at operating temperature by driving it for about 10 minutes. 2: Open the hood of the Galant and locate the automatic transmission fluid reservoir and dipstick on the driver's side of the engine. The dipstick is labeled "ATF" and is red. 3: Pull the dipstick out of the reservoir, wipe it clean with a rag and reinsert it. Remove it once more and take the measurement of the current fluid level. Do not add any fluid if the fluid is already at the "Full" line; overfilling the reservoir can damage the transmission. If the measurement is between the "Full" and "Add" lines or below the "Add" lines, then continue to Step 4: Insert a funnel into the reservoir and pour a small amount of transmission fluid into the container. Check the fluid levels again by removing the funnel and inserting the dipstick into the reservoir. Pull the dipstick back out and read the fluid level on the dipstick. Continue this process until the fluid is at the "full" line. If you would like to do a transmission filter kit I have found a site with full color pictorial and instructions. Pretty handy!!!

Believe it or not, it doesn't have one. It just has a cap with no dipstick over the tranny fluid fill tube. You have to take it to the dealer, or a shop with the "speacial tool" (dipstick) to measure it. Some speculate that this may be due to the fact that Chrysler has had a bad rap for a number of years related to their transmissions. The don't want consumers adding the wrong type of tranny fluid (dextron) to the vehical thereby creating shifting and other issues. Rediculus if you ask me. Hope this helps. Please remember to rate my answer. Thanks.

it may not have a dipstick some car do not have one
I think it crazy to