2000 Subaru Outback Logo

Related Topics:

t
tim gilreath Posted on Jun 08, 2017

I have an 2000 subaru outback, and my wife said the abs light came on,the break pedal made a noise,then all the dash lights came on and stayed on, whatcould have

5 Related Answers

Anonymous

  • 15 Answers
  • Posted on Jan 08, 2009

SOURCE: abs light on, cruise control and engine light 2007 subaru outback

55 EGR Temperature Sensor or Circuit

ABS light is nothing to do with code 55 separate fault circuits.

Under dash there are two wires with mini spades at the end, connect one of them to the single black multiplug in position 2. Thats RHS plug inlet when you hold plug with tab lock on top.
ABS sensor should then flash up error coded. Ignore code 11 thats a initial flash to let you nknow the difference between a fast and slow flash.

Let me know what code flashes up and I will tell you the symptom,

Dan

Ad
mx5turbo92

mx5turbo92

  • 545 Answers
  • Posted on Jun 04, 2009

SOURCE: i have a subaru legacy outback, abs light comes on

one of your abs sensor is bad or the abs motor,go to local shop to diagnose which sensor,shop usually charge $ 60 to diagnose abs system,good luck, let me know ..

Anonymous

  • 119 Answers
  • Posted on Jul 19, 2009

SOURCE: The ABS,Brake Light,Battery light go on and off sporadically while driving.Does this indicate an Alternator failure or a sensor/computer problem?

yes it's most likely a alternator problem,usually the internal diode bridge breaks causing all lights you mentioned to come on,if this happens at a idle open the hood and remove green connector on alt.if lights go out you've found the problem

Anonymous

  • 119 Answers
  • Posted on Aug 17, 2009

SOURCE: 1998 Subaru Outback with parking lights staying on.

turn off switch on top of steering column

Jonah Oneal

  • 14092 Answers
  • Posted on Nov 14, 2009

SOURCE: Check engine light on. P0325, P0420 2000 Subaru

CODE PO420 CATALYST SYSTEM EFFICIENCY BELOW THRESHOLD BANK I * CODE PO325 KNOCK SENSOR NO.1 CIRCUIT MALFUNCTION BANK NO.1 OR SINGLE SENSOR

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Abs subaru outback 1999 not light, no error codes but does not work.

Have the abs removed and checked for operation. If you press the pedal hard enough to produce a skid but it doesn't then the abs is working. Under heavy braking from speed you will get a pulsating feeling in the pedal as the brakes are released and then re applied very quickly. If you are finding that no mater how hard you press there appears to be no assistance to brake then the problem will be in the booster and not the ABS.
1helpful
1answer

My subaru outback 2004 abs and traction control light on while driving also have no cruise control function as well

you have a dry joint or damaged wheel sensor, and the only way to find it is 1 at a time until you find it, these lovely little items effect all your problems mentioned
0helpful
2answers

The brake light stay on

If your referring to the rear brake lights, it can be either a switch or a relay. The switch is located on or near the brake pedal, the relays are located under the hood in a black rectangle compartment. If your referring to dashboard light, I would check for a stuck parking brake.
0helpful
1answer

ABS and VDC lights stay on - 2001 Subaru Outback VDC

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can try
4helpful
2answers

Abs light stays on my 99 subaru outback. what should i do to get it off

you have to go to your local garage and have the car computer scanned

this will tell you which wheel sensor is not working properly, or abs module
0helpful
1answer

My ABS light on my 99 subaru outback has been on. we were able to turn it off by replacing a blown fuse but now the ABS keeps kicking in everytime I stop making the brakes pulsate. I needed the light to...

If the light is on , DTC'S - diagnostic trouble code's are stored . These would point to a fix . Your best bet , take your vehicle to a qualified repair shop .
3helpful
1answer

I have a subaru legacy outback, abs light comes on

one of your abs sensor is bad or the abs motor,go to local shop to diagnose which sensor,shop usually charge $ 60 to diagnose abs system,good luck, let me know ..
4helpful
1answer

The ABS,Brake Light,Battery light go on and off sporadically while driving.Does this indicate an Alternator failure or a sensor/computer problem?

yes it's most likely a alternator problem,usually the internal diode bridge breaks causing all lights you mentioned to come on,if this happens at a idle open the hood and remove green connector on alt.if lights go out you've found the problem
0helpful
1answer

2000 subaru outback rear door stuck in open mode

Disconnect the wires going to the spring loaded switch in your hatchback.
0helpful
2answers

Abs light on, cruise control and engine light 2007 subaru outback

55 EGR Temperature Sensor or Circuit

ABS light is nothing to do with code 55 separate fault circuits.

Under dash there are two wires with mini spades at the end, connect one of them to the single black multiplug in position 2. Thats RHS plug inlet when you hold plug with tab lock on top.
ABS sensor should then flash up error coded. Ignore code 11 thats a initial flash to let you nknow the difference between a fast and slow flash.

Let me know what code flashes up and I will tell you the symptom,

Dan
Not finding what you are looking for?

210 views

Ask a Question

Usually answered in minutes!

Top Subaru Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Oliver Street

Level 2 Expert

73 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...