I am trying to find out how to remove the ignition switch from a 2000 vw beetle.

Removing hub cap of the wheel VW - YouTube

? 0:35
https://www.youtube.com/watch?v=LLYlHWtS4Fw
Jul 12, 2008 - Uploaded by rebuli2008
old beetle. ... removing hub cap of the wheel VW. rebuli2008 ... How to Remove or Take Off Plastic Hub Caps - Hubcaps.com - Duration: 2:54.

How to Remove hubcaps from a VW Beetle Volkswagen Bug

vehicle-maintenance.wonderhowto.com/...to/remove-hubcaps-from-vw-...

Sep 4, 2008 - How to Remove hubcaps from a VW Beetle Volkswagen Bug ... the proper way to take off your hubcaps for your vintage VW Beetle. ..... I'm Having Problems Loosening the Adjuster on My Drum Brakes on a 2000 Isuzu Rodeo.

Replace the retarded ignition switch,the electrical part of the switch only if possible.

the fan relay switch is under the drivers side dash, you need to remove panel, then slide upside down to view relay switches, fan relay is in first row next to large relay second over.

Removing:

• Switch off all electrical consumers, switch off ignition key and remove ignition key.
• Remove rear luggage compartment side panel trim (left or right).

• Remove 3 nuts, arrows, and remove housing.
• Remove bulb holder.

Installing:

• Install bulb holder.
• Insert housing into body opening.
• Tighten nuts.
• Install applicable rear luggage compartment side panel trim.

Rear Light Bulb Holder Removing And Installing:
Removing:

• Disconnect electrical connector.
• Depress retainers, arrows, and remove bulb holder.

Installing:

• Install in reverse order of removal.

And the Center Mounted Brake Lamp.
High mount Brake Light Removing And Installing:
The high mount brake light is installed in the rear shelf.
Removing:

• Switch off all electrical consumers, switch off ignition key and remove ignition key.
• Disconnect electrical connector from high mount brake light.
• Remove rear shelf
• Un-clip high-mount brake light from rear shelf, arrows.
• Install in reverse order of removal.

NOTE: The bulb holder base plate contains soldered- in light emitting diodes (LEDs) that are not replaceable. In the event of LED malfunction, replace complete bulb holder.
Additional

its your switch. Find the reversing light switch and change it[you can check it by connecting the 2 wires going to it together if the light comes on then its the switch if not then its wiring

You don't have the proper key. The flip key assembly has a chip in it that lets the car keep running. Use old key assembly. To test put the old ket fob next to the ignition switch and see if it keeps running,

the electrical portion of you ignition switch is going out.

vw uses coil on plugs so each plug has a coil under engine cover on top of valve cover check fuses first for your other problem

The plastic ignition switch is held in with a philips screw. You will need to remove the ignition lock cylinder to get to it. A easy way to check is to unplug the wires going into the back of the lock housing and plug in the new switch, without removing anything.

remove the radio and get some new glasses