SOURCE: How do I boost the air conditioning system on my 2001 Olds Aurora
On the caps that screw on the two AC ports you will see a Letter L or H.You need to add to the L(low) side and if you have no caps the hose connector on the can of freon will only fit the low side.Also,most of the time the low fittting is smaller than the high fitting is. When adding have your car running with the AC on and on the max setting.Hope this helps.John.
SOURCE: how to change km to miles on 2001 aurora oldsmobile
When the system is on or off, push the ON/OFF button down for three seconds to change the display between English and metric. This will also change the digital screen for the climate control system between English and metric.
SOURCE: how do i remove a radiator from a 2001 oldsmobile
Click on this link for basic diagram: http://www.autozone.com/autozone/catalog/parts/jobDiagram.jsp?engineCyl=8&ymmeId=2001/37/35/515&imageURL=&categoryDisplayName=Cooling+%26+Heating&productType=00&parentId=172 First thing is to drain your radiator of all coolant by opening pipcock at base of radiator (catch the old coolant in a pan but I myself would not reuse it.) As you can see in the diagram, you'll need to remove upper and lower radiator hoses and overflo hose. (Remove all hoses at the radiator only...no need to remove completely.) If applicable, unattach transmission cooling lines from the radiator. (If desired, you can temporarily plug ends of tranny lines with clean pieces of rag.) Last, there are two radiator hold down clamps which are easy to get at and remove, as you can see in the diagram. After removing these you should be able to lift the old radiator straight up and out. Hopefully you will not need to remove your cooling fans. Carefully reverse the process with your new radiator, refill the system and you're done. How "cool" is that??? Hope I helped
SOURCE: How do you change the brakelight on a 2001
pop the trunk and you should see two screws along the rear taillight assembly. remove the screws and the taillight assembly should pop out. you can then twist the bulb and pop it out along with the harness, put the new bulb in and reverse.
If it's your 3rd brake light, the bolts holding it in against the rear window will be found inside your trunk along the top side of your trunk (get in and look up)
34 views
Usually answered in minutes!
×