Hi I have A 2016 outback journey and the wiring in the fridge is up agenst the furnace is this ok cheers byron

Question edited for clarity.
Question moved to subcategory.

Following the sequence pattern shown in the appropriate service manual, tighten the camshaft bearing cap bolts to 89 in-lbs.

https://www.moparmagazine.com/2016/06/camshaftfollower-replacement/

https://www.google.com/search?q=2016+Dodge+Journey+3.6.+camshaft+Torque+specs

..

https://www.dodgejourneyforum.com/topic/7837-wiring-diagram-needed-yes-ive-searched/

https://www.justanswer.com/dodge/4pmpj-dodge-journey-stereo.html

You realise the speakers in the vehicle are only rated to handle the power of the standard amp?
..

There isn't one. The alternator SUPPLIES power, it doesn't use it.

Fuse Box Diagram Dodge Journey (2011-2019) - Fuse-Box.info

fuse-box.info > dodge > dodge-journey-2011-2018-fuses

Fuse box diagram (location and assignment of electrical fuses) for Dodge Journey (2011, 2012, 2013, 2014, 2015, 2016, 2107, 2018, 2019).

I would have the lock actuator looked at.

hello
u will find a lot of wiring diagrams and circuit diagrams help books and stuff like this at reliable-store
the girl in the chat box can help u instantly... im a frequent buyer there since Im a mechanic so take help from there

was the reading taken when cold or hot --you can add water to your coolant but be advised it will change the cooling or anti freezing temps

Yes. would help to add half antifreeze half water. Should cost 0 to have it checked at any station.

No do not add tap water, use only purified water or 50/50 coolant mix.

Hi Jerry:
It is now 2016.
What machine do you need the starter wiring diagram for?
Reply as a COMMENT to this post and I will try to help.
Cheers

Hiya,

Here you go:

2.5L Engine To Remove:

1. Disconnect the battery ground cable.
2. Remove the air cleaner housing.
3. Vehicles with 5-spd transmission: Remove the clutch slave cylinder and set aside.
4. Disconnect the knock sensor wire harness retainer from the coolant hose.
5. Disconnect the knock sensor (KS) wire connector.
6. Remove the mounting bolt and knock sensor from the engine block.

Hope this helps...

Cheers,