1997 Subaru Legacy Logo

Related Topics:

Donald Klecker Posted on Jan 21, 2017

Removing steering column cover on 1997 Subaru Legacy Outback

5 Related Answers

Anonymous

  • 710 Answers
  • Posted on Apr 24, 2009

SOURCE: Cause of noise in front differential of 1997 Subaru Legacy Outback.

there is a plug on the shaft-side of the differential. Using a ratchet remove the plug and with the engine OFF, stick your finger inside the hole and you should get fluid just below the threads of where the plug goes in.

Ad
mx5turbo92

mx5turbo92

  • 545 Answers
  • Posted on Jun 04, 2009

SOURCE: i have a subaru legacy outback, abs light comes on

one of your abs sensor is bad or the abs motor,go to local shop to diagnose which sensor,shop usually charge $ 60 to diagnose abs system,good luck, let me know ..

subytech1

Brandon Johnson

  • 253 Answers
  • Posted on Aug 09, 2009

SOURCE: Power steering pump replacement for Subaru Outback

REMOVAL

  1. Remove ground terminal from battery.
  2. Remove pulley belt cover bracket.



  1. Loosen lock bolt and slider bolt and remove power steering pump drive V-belt.
  2. Disconnect connector from power steering pump switch.



  1. Disconnect pipe C and suction hose from oil pump. CAUTION:
    • Do not allow fluid from the hose end to come into contact with pulley belt.
    • To prevent foreign matter from entering the hose and pipe, cover the open ends of them with a clean cloth.



  1. Remove bolts which install power steering pump bracket.



  1. Place oil pump bracket in a vise, remove two bolts from the front side of oil pump. CAUTION: Do not place oil pump bracket directly in the vise; use soft pads and hold oil pump lightly to protect the pump.



  1. Remove socket from oil pump.
  2. Remove bolt from the rear side of oil pump.

Anonymous

  • 2 Answers
  • Posted on Aug 29, 2009

SOURCE: My 1999 subaru parking lights will not turn off

the rocker switch on top of your steering column is on.

Anonymous

  • 127 Answers
  • Posted on Oct 03, 2009

SOURCE: headlight low beam

Test to see if you have voltage at the bulb connector in low beam position. I'd almost bet that if there is no voltage there for the low beams that you have a bad high/low switch.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where can i get an air flow sensor for the 1997 suburu outback legacy modelej25 and the power steering rack for the same model car

You can get MAF sensor at dealership but expensive or can buy used, cheap on subaruoutback.org forum. Same for steering rack. However,,Rockauto also has good prices on new parts.
0helpful
1answer

Is a rear diff from a 1997 subaru legacy wagen with a 2.2l inter changeable with a 1997 subaru legacy outback with a 2.5l ?

the only way you can do this is if you can identify the gear ratios from both cars with the transmission codes found on the strut tower plate.
see this list to check for matches, read it carefully its a ton of info
subarugears narod ru
0helpful
1answer

Can you switch a rear diff from a 1997 subaru legacy wagen with a 2.2l inter changeable with a 1997 subaru legacy outback with a 2.5l ?

the biggest draw back that you will have to check first is the ratio of the diffs you want to change. If they are not the same but will fit then you will destroy the 3rd diff in the transmission from excessive use.
2helpful
1answer

1997 Subaru Legacy Marker lights won't turn off. My daughter just purchased this car at 3 today 4/15/11.

Check the switch on top of the steering column. It turns the marker lights on and off.
11helpful
1answer

My 1999 subaru parking lights will not turn off

the rocker switch on top of your steering column is on.
7helpful
1answer

1998 Subaru Outback with parking lights staying on.

turn off switch on top of steering column
3helpful
1answer

Steering wheel clicks on 1998 Subaru Legacy Outback wagon

steering column bearing sounds like a worn out steering column... jack the front wheels off the ground both sides relieve load on steering wheel to see if it lessens the amount of feel and noise, if it does it shoud be the column bearing, replace bearings or complete column,,, also try with the wheels off the ground and safely supported to manualy steer the wheels by hand and see if you feel in roughness or hear any noises,should some minor resistance but be smooth in it movement if everything suspension and steering component wise is in good working condition... please rate my help.. thanks...
1helpful
1answer

Replace passenger mirror 1999 subaru outback

you need to remove door panel to unplug miroor connection
2helpful
1answer

Cause of noise in front differential of 1997 Subaru Legacy Outback.

there is a plug on the shaft-side of the differential. Using a ratchet remove the plug and with the engine OFF, stick your finger inside the hole and you should get fluid just below the threads of where the plug goes in.
Not finding what you are looking for?

235 views

Ask a Question

Usually answered in minutes!

Top Subaru Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Oliver Street

Level 2 Expert

73 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...