Before changing the pump did you test for B+ voltage at the pump and check the ground circuit . Jump B+ voltage to see if it runs ? Does it have the heated washer system ? How about the washer relay , did you check it ?
With the ignition in the ON position, accessory voltage is supplied through the 25A WPR fuse to the WIPER relay, the WIPER HI relay and the WSH relay that are all located in the under hood fuse block.
SOURCE: winshield washer pump has stopped pumping on 1996
Sounds like pump alright Unbolt tank from car and pump should be screwed to bottom of tank Another way is fit a universal inline washer pump Up to you whether you want to keep your car original
SOURCE: how do you access the windshield washer pump on
The washer pump is located on the bottom of the wash fluid bootle. you can access it by removing the front passanger fender liner..
SOURCE: 2005 Chrysler Pacifica Washer Pump
The washer pump is located in the bottom of your windsheild washer reservoir. You will have to remove the wheel well cover to access it and check the plug in harness to make sure it is connected. Place a voltmeter on the to leads of the harness and have an assistant push the windshield washer button with ignition on. There you will see if your getting volts to the end of the harness. If you do, then the pump is bad. Replace it while you have access to it.
SOURCE: Hi, where is the fuel
Hi There.
you may have to check in the trunk for an inspection panel or remove the gas tank to get to the fuel pump.
SOURCE: Where is the windshield washer
Normally they are located on the bottom of the windshield washer resivoir or nearby.
1,052 views
Usually answered in minutes!
×