1994 Plymouth voyager vacuum diagram - 1994 Plymouth Voyager

SOURCE: Needed serpentine belt diagram for a 91 ply. voyager 3.3L engine

Here's a link to the diagram you need...

http://www.gates.com/common/part_locator/view_diagram.cfm?id=S7006

Good luck and please rate this solution. Thanks.

Testimonial: "Looks good."

SOURCE: 1994 plymouth voyager heating problems. Just

After the car warms up feel the heater hoses that go into the fire wall from the motor both should be warm if only one is warm and the other is cool the heat valve that opens the flow of antifreeze to the heater core is not functioning locate the valve (either under dash in passenger compartment or in the egine compartment) it has a vacuum line going to it and it should have vacuum when the heat is on if not replace the vacuum line or valve itself. Back flush heater core and also be sure the level of antifreeze is up to the top low antifreeze will cause no heat to occur.

SOURCE: Serpentine diagram for a 1997 Plymouth Voyager

Make a drawing of where the belt and pulleys are before you remove the belt. You won't need a diagram,you will have made your own and be done before you ever find one,unless you have a shop manual already.

SOURCE: 1994 plymouth voyager serpentine belt diagram

My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

CLICK on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
http://www.2carpros.com/car_repair_information/year/1994/make/plymouth/model/voyager/1994_plymouth_voyager_drive_belt_routing_diagram.htm

SOURCE: need 1993 plymouth voyager serpentine belt diagram

Which engine?
To replace the drive belt or serpentine belt on a Voyager check the engine size. For 2.4L engines, a serpentine belt runs the air conditioning compressor and alternator. For 3.0L models, the alternator and power steering share a belt with a separate belt for the AC. Dodge recommends checking the belts every 15,000 miles or 12 months for possible replacement. I have gone 3 yrs with one.. it will start squealing when you turn on the heater to defrost..

http://www.automd.com/46/how-to-replace-a-serpentine-belt/

Most replacement belts have a diagram on the package. However, the easiest way is to pay close attention to the belt you are taking off, and replace the new one the same way. The pulleys themselves are usually 'grooved' or 'smooth' which tells you whether the front or back of the belt is against it. The hardest part is figuring out how to release tension on the idler-pulley. If you can get the belt on and the idler/tension pulley (same thing) pulls the belt tight, chances are you got the belt right. If you don't know what I mean, then the mostest best way is to get a Clymer Manual and read up. Its really a simple thing to do yourself.

I used a long heavy duty screw driver to release the tension on a Pontiac Sunbird.. the belt will only fit on one way..