Question about 1993 Buick Regal

1 Answer

I have a 1993 buick regal gs. the door fob will only lock/unlock in extreme hot or cold temps. I have changed batteries and tried resetting but doesn't help

What should I do next

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Buick Master
  • 10,543 Answers

Try lubricating the door latch mechanisms on all the doors.

Posted on Mar 16, 2016

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
davidpenman

David Penman

  • 255 Answers

SOURCE: 98 Buick Regal -engine quits

ok its one of two things you need to check when it cuts off if you have spark or fuel if you lose fuel pressure replace pump it gets hot and makes noise like its running but its not pumping fuel and if you lose spark you need to replace ignition control module has a hair line crack in it and when gets hot the crack expands and loses contact and wala no spark

Posted on Aug 16, 2009

Anonymous

  • 145 Answers

SOURCE: Changed oil and filter on my 1993 Buick Regal GS.

oil sending unit is probably bad. just replace it, common.

Posted on Sep 16, 2009

Jonah Oneal

  • 14092 Answers

SOURCE: Buick regal door locks not working correct

YOUR RELAY OR RELAYS COULD BE FAULTY.

Posted on Sep 18, 2009

kayzack519

Jason Conway

  • 226 Answers

SOURCE: 1993 Buick Regal - electric door locks, my Buick

did you try changing the master switch(controls all windows and locks)? i would hook it back up to the way it was and change that master switch

Posted on Dec 06, 2009

princeofscot

Thomas Campbell

  • 288 Answers

SOURCE: I have a 2004 Buick

you should check all the fuses maintanence once in a while so you can replace the same amp fuses though. Have you put a new battery in your fob because the battery in those do go bad. It could be a short in some of the wires that is doing this so if you know how to use a multimeter to test the wires of the radio connections and any other wires but plus check your ground wires too.

Posted on May 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Buick Regal. Power door lock swith will not lock doors.


Remove the door panel and unplug the connector to the door actuator. Probe the contacts with a voltmeter set on DC volts. Then operate the lock/unlock switch. You should see the voltage toggle from +12 volts to -12 volts. If you do, then the wiring, switch and connector are good and you have a bad actuator. Be prepared to start replacing all of them because they all operate the same number of cycles.

Jul 28, 2017 | 2003 Buick Regal

1 Answer

1998 buick regal gs heat blows hot on passenger side and cold on the driver side.


Same problem on my 98 Regal GS; remove glove box, locate the blend door actuator, (black odd shaped box with metal "ring"). Remove the box and manually turn the blend door shaft it was attached to. If you get cold air, it's the actuator you removed. About 30-40 dollars.

Nov 04, 2011 | 1998 Buick Regal

1 Answer

1996 buick park avenue's security light comes on and then will not start. after about 5 min it will start. what the heck!


change the battery in the key fob for locking and unlocking doors. once the battery is new lock and unlock the doors 2 times it should sinc the system again

Sep 30, 2010 | 1993 Buick Park Avenue

1 Answer

1993 Buick Regal - electric door locks, my Buick driver's side door stopped unlocking the door by the switch. It was only the driver's door all other doors work fine. I changed the actuator and then the...


did you try changing the master switch(controls all windows and locks)? i would hook it back up to the way it was and change that master switch

Dec 06, 2009 | 1993 Buick Regal

1 Answer

Passenger side only blowing cold air.


You need to replace the "blend" door actuator motor on the pass side. I recommend getting that from your nearest gm dealer to ensure proper fit. When you adjust the air from cold to warm to hot, the blend door moves to direct the right amount of cold, or warm, or hot air your desire on that side of the vehicle

Dec 04, 2009 | 2000 Buick Regal

1 Answer

A/c blows hot air on drivers sde


The actuator door on the driver's side is out of position and needs to be reset. Remove the negative battery cable for 1/2 hour to reset the computer. Start the HVAC system and you should be able to hear the door adjusting itself and cold should come out of the driver's side vent.

Sep 19, 2009 | 1999 Buick Regal

1 Answer

98 Buick Regal -engine quits


ok its one of two things you need to check when it cuts off if you have spark or fuel if you lose fuel pressure replace pump it gets hot and makes noise like its running but its not pumping fuel and if you lose spark you need to replace ignition control module has a hair line crack in it and when gets hot the crack expands and loses contact and wala no spark

Aug 15, 2009 | 1998 Buick Regal

Not finding what you are looking for?
1993 Buick Regal Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...