How do you know the timing needs to be set? Check library for a repair manual. Usually the timing marks are marked on the front balancer pully mark the designated mark with something like whiteout so you can see it properly with a timing light.
SOURCE: Hyundai Lantra 19999 Timing Mark
are you setting the timing belt or just setting the timing with a light ? if you are setting the timing it should be set at about 10 before top dead center or maybe would run a little better at 12 or so thanks jerry holler if you have more .
SOURCE: How can I set ignition timing for a 1993 Nissan pickup D21 2.4L
the mark to the right of the pully will be 0 .. it will be like this. 8 6 4 2 0
SOURCE: set timing on 1989 f150 5.0
Run codes first and allow it to enter self test mode. The computer is at fault or the circuit related to the PIP. I don't think you are doing anything wrong in setting the timing as it is supposed to advance beyond the initial setting once the PIP bus is reinserted..
SOURCE: The timing on my Geo Tracker is off.
Sounds like you have the timing belt off a notch or two. Set the crank pulley at the notch and TDC then remove the top screws on the belt cover and pull the cover back far enough to shine a light to check the cam pulley mark against the notch it should align with !
SOURCE: what do I set the timing to, on a 1986 Toyota
Carbed models should be started at 0 degrees, Fuel injected models at 5.
297 views
Usually answered in minutes!
×