Code p0600 on 96 grand voyager Plymouth 3.3 help

Hey Joe,here's a link to your codes,may be your EVAP purge solenoid circuit is open or short condition detected.Click here to see.

P0167-/ 02 (oxygen) Sensor Heater Circuit Malfunction (Bank 2 Sensor 3)

double check your code. cannot find a listing for a p1784. please advise as to the engine size

For the 1999 Plymouth Grand Voyager 3.3L:

Firing Order:
1-2-3-4-5-6
Cylinders:
......(back).......
|...1....3....5...|
____________
|...2....4....6...|
......(front)

Ignition Coil Connections:
(back)
|.6...3.|
|.4...1.|
|.2...5.|
(front)

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

1999 Plymouth Truck Grand Voyager 2WD 3.8L MFI 6cyl
* The Vehicle Speed Sensor is located Mounted on transmission
* The Sensor - Transmission Speed is located Mounted on transmission

Hope this help (remember comment and rated this).

Misfire at Cylinder # 3. One of three things:
1. Spark Plug malfunctioned.
2. Wire going to Cylinder # 3 is malfunctioning.
3. Electronic Coil is malfunctioning at Post # 3.

hallo
first try to dicconect batery for one minute. this will reset (erase) foult code. do test drive and check error codes again (within 5 sec switch ignition key on-off, on-off, on. count mil flashes, write it down on paper. no 12 and 55 (end) are normal. everithing betwin are errors. if error 33 presist there is something wrong with AC reley or wiring.
Marko

I would try a tune up.

According to minimopar.knizefamily.net, fault code 31 is "Purge Canister/EGR Solenoid".

likely a wiring issue to the tcm or the tcm relay, check the speed sensors as well, I've fixed alot of plymouth that have had the same pro try checking all of your connects with the batt disconcted