2000 GMC Sierra Logo
A
Anonymous Posted on Sep 24, 2014

My first two speed for heater blower don't work on my 2000 Sierra why?

1 Answer

robert wales

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • GMC Master 4,977 Answers
  • Posted on Sep 24, 2014
robert wales
GMC Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Mar 01, 2011
Answers
4977
Questions
0
Helped
1332646
Points
59541

This is an indication of the blower motor resistor is bad and needs replacing. the resistor circuit for those speeds are bad.

5 Related Answers

Anonymous

  • 73 Answers
  • Posted on Sep 13, 2008

SOURCE: 2000 cherokee sport blower motor control

It is a bad blower motor resistor and it is mounted on the bottom of the A/C heater housing on the passenger side of the vehicle under the glovebox area. Hope this helps. Please rate this a fixya if it helps. Thanks.

Mike

Ad

Anonymous

  • 153 Answers
  • Posted on Dec 14, 2008

SOURCE: 02 GMC Sierra-heater-a/c motor only works on high speed

Check or have checked the blower motor resistor. These resistors will cause this problem. I would go this route first as these are relatively inexpensive and usually the problem.

Anonymous

  • 1 Answer
  • Posted on Jan 17, 2009

SOURCE: 2003 GMC Sierra heater Blower wont shut off

My 2003 Sierra's blower came on by itself in the garage while I was sleeping and ran the battery completely down. I had to replace the blower switch located under the glove box next to the blower at the bottom of the right corner of the dash. The switch is in front of the blower and held in by two screws. Disconnect the two wire connections. This is a "dealer only" part and cost me 65.00. Also check the wire harness with seven wires connected to it for melted plastic. It will be marked "ABCDEFG". If it has melted, you'll need to replace it. Pay attention when reinstalling either part, that the wires "ABCDEFG" match the switch in that order.

Anonymous

  • 221 Answers
  • Posted on Mar 17, 2009

SOURCE: 2004 Ford F150 - AC/Heater blower speed 1 & 2 not working.

You might have a bad speed selector switch, or your blower motor resistor is faulty.

ministock48

Bobby Memory

  • 258 Answers
  • Posted on Oct 22, 2009

SOURCE: 1996 GMC blower motor only works on high speed.

more than likely yes the resistor

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2000 gmc Sierra, a/c heater control switch only works on numbers 4

You have a bad blower motor resistor that is bad.It is located on the passengers side under the dash.Just turn the blower on the speed that it works and follow the blower motor noise when it is on.The resistor is what controls the speeds.You will probably find that the wires on the connector are melted.You will have to replace the connector and the resistor.I have done a few of these repairs.You will need to remove a plastic panel from under the dash first.3or 4, 7mm screws.You might get a letter in the mail from G.M.You can also cal the dealership and find out if your vehicle is involved in this letter.Hope this helps.Good luck.
0helpful
1answer

05 GMC sierra heater blower stopped working. It used to work on setting 1-4 but lost 4 a couple weeks ago and now none of them work. Is this a bad blower , resistor or both?

The resistor is most likely bad but should still work on the highest setting.Would check pigtails to the resistor and to the blower motor for burnt or discolored wiring.You can try tapping the blower motor and wiggling the wiring harness too see if it will work on the highest setting. It is possible that the blower motor is bad as well typically when you lose the speed selection it is the resistor but you should always have high speed.
0helpful
1answer

2006 gmc sierra , heater actuator

CHECK WITH DEALER, THIS IS A WARRANTY ITEM. BAD FRON FACTORY ON ALL TRIL BLAZERS, ENVOYS, AND DENALIS.
1helpful
1answer

My blower fan only works on high

you will need to order a blower resister its easy to swap out
2helpful
2answers

No heat,engine temp.is normal

the valve that allows the hot water into the heater core is not opening. most likely electronic issue. also check all vacuum and electric lines.
0helpful
2answers

My 2000 gmc sierra truck heater heats up but sometimes don't turn down

try replacing the blower motor resitor

http://www.buywiring.com/products/2-7-wire-blower-motor-resistor-harness-with-12-pigtail?template_id=2&image_id=7

in the picture it is the part with the white sticker

It is in the duct work under the passenger side dash.

I got mine locally for under $50
0helpful
1answer

Heater not working

The problem is probably the blower motor resistor. I'm not sure where yours is located exactly. They can be on the firewall under the hood or some are near the blower motor under the dash.
0helpful
1answer

02 GMC Sierra-heater-a/c motor only works on high speed

Check or have checked the blower motor resistor. These resistors will cause this problem. I would go this route first as these are relatively inexpensive and usually the problem.
0helpful
2answers

Heater fan only works on 5

YOU NEED TO REPLACE THE BLOWER MOTOR SPEED CONTROL RESISTOR.
0helpful
1answer

Blower Motor

replace blower motor resistor also check the plug at resistor if it is burnt replace plug also
Not finding what you are looking for?

90 views

Ask a Question

Usually answered in minutes!

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...